Oxford Garden SIG60 User manual

15 Kingbrook Parkway, Suite 100 Simpsonville, KY 40067 p. 877.866.3331 f. 502.719.8888 oxfordgarden.com
Ver. 06.30.20
SIGNATURE BENCH 5’ - SIG60
ASSEMBLY INSTRUCTIONS
COMPONENTS
HARDWARE
FINISHING ITEMS
Medium Grit Sandpaper
NOTE: A hammer and a phillips head screwdriver (not provided) will be needed for the assembly of this bench.
NOTE: If the furniture is going to be placed on a concrete or tile patio, it should first be rinsed well to remove the
sawdust that may cause some staining.
Right Arm Assembly
Quantity: 1
Left Arm Assembly
Quantity: 4
2
Back
Quantity: 1
3
Seat
Quantity: 1
4
Front Rail
Quantity: 1
5
Wood Screw
Quantity: 8
B
Dowel
Quantity: 12
A

Ver. 06.30.20
STEP 2
Locate the small label on the bottom of the seat that
reads “front”. With the front of the seat toward the front
of the bench, line up and insert the front rail and seat
into the right leg assembly. Insert the large rounded
pegs at the front and rear of the seat into the back
and front rail.
INSTRUCTIONS
STEP 1
On a clean flat surface, lay right leg assembly on its
side mortise holes facing up. Place the back into the
mortise of the right leg assembly.
Ver. 2019.03.24
STEP 3
Line up and place left leg assembly onto those parts
already assembled.
STEP 4
With a hammer, drive dowels into the predrilled holes
found on the front of the leg assemblies to hold the front
rail into place. Drive the remaining 8 dowels into the
predrilled holes located on the back of the leg assemblies
to hold the back in place. Insert the tapered end of the
dowels first.
STEP 4 (detail)
NOTE: The dowels should be easily driven in flush. If there
is strong resistance, do not force the dowel. Sand to
smooth off areas around the dowel pins.
STEP 5
Using a phillips head screwdriver; screw the 8 total wood
screws into the predrilled holes on the underside of the
seat to attach the seat to the seat back, front rail and arm
assemblies as shown. Turn bench upright and enjoy!
3

4
5
5
4
2
A
3
5
2
3
2
A
A
B
B
B
B
B