Oxford Garden TRAVIRA User manual

15 Kingbrook Parkway, Suite 100 Simpsonville, KY 40067 p. 877.866.3331 f. 502.719.8888 oxfordgarden.com
Ver. 06.30.20
TRAVIRA BACKLESS BENCH - 48”
ASSEMBLY INSTRUCTIONS
COMPONENTS
HARDWARE
NOTES
8 of the 13 bolts are pre-assembled into protective slat. SEE STEP 1 You will remove these 8 bolts shown below off of
protective slats off both ends of the seat assembly using the allen wrench provided. Protective slats are to be removed
and discarded but can be recycled.
DO NOT DISCARD BOLTS; these will be the remaining 8 bolts of the 13 bolts total you will need to assemble this bench.
Long Bolts
Quantity: 13
A
Allen Wrench
Quantity: 1
B
Right Leg Assembly
Quantity: 1
Left Leg Assembly
Quantity: 1
2
Seat
Quantity: 1
3
Support Rail
Quantity: 1
4
Protective Slat
A
A

Ver. 06.30.20
Ver. 2020.01.28
STEP 2
Connect the right leg assembly to the seat using
the four bolts that were removed from the protective
slat in Step 1.
INSTRUCTIONS
STEP 1
Lay seat assembly on a clean flat surface. Using the
allen wrench provided, remove the protective slat. Do not
discard bolts , you will use them for the assembly of the
bench. Repeat on left side.
NOTE: The protective slat is a recyclable plastic
Simply place in recycle bin.
A
STEP 3
Next, insert support rail to the already assembled right
leg. Secure using two bolts as shown.
Note: Keep supported until remaining leg assembly is
secure.
STEP 4
Insert the remaining leg into the already assembled
parts. Secure the leg to the support rail by using two bolts.
STEP 5
Further secure the leg by using four bolts as shown.
STEP 6
Turn right side up and enjoy!
A
3
Protective Slat
A
A
3


A
A
4
4
2
2
A
A
A