Oxford Garden CLASSIC ROCKER User manual

15 Kingbrook Parkway, Suite 100 Simpsonville, KY 40067 p. 877.866.3331 f. 502.719.8888 oxfordgarden.com
Ver. 06.30.20
CLASSIC ROCKER
ASSEMBLY INSTRUCTIONS
COMPONENTS
HARDWARE
FINISHING ITEMS
Medium Grit Sandpaper.
NOTE: A hammer (not provided) will be needed for the assembly of this bar chair.
NOTE: If the furniture is going to be placed on a concrete or tile patio, it should first be rinsed well to
remove the sawdust that may cause some staining.
GLUING INSTRUCTIONS: Correct assembly of this chair requires glue to be applied to the final assembly
joints using the supplied glue. To properly glue these joints follow the directions below:
a. Lay the assembly part flat and apply a liberal amount of glue into the mortise using the brush and
glue supplied. Use the brush to make sure the glue is thick on the inside walls of the mortise.
b. Apply a liberal amount of glue to the complete tenon using the brush to make sure the glue has contact with the entire tenon.
c. Assemble the parts as instructed in the instruction steps. After assembling the glued parts, use a damp
cloth or sponge to clean up any excess glue from the outer surface of the furniture.
Right Arm Assembly
Quantity: 1
Left Arm Assembly
Quantity: 1
Right Rocker
Quantity: 1
Left Rocker
Quantity: 1
5
Seat
Quantity: 1
6
Back
Quantity: 1
7
Front Seat Rail
Quantity: 1
8
Back Seat Rail
Quantity: 1
Dowels
Quantity: 28
A
Wood Screws
Quantity: 4
B
Wood Glue
Quantity: 1
C
Wood Glue
Brush
Quantity: 1
D

Ver. 06.30.20
INSTRUCTIONS
STEP 1 * Apply glue in this step. (See pg.1 for instruction.)
Apply wood glue provided and attach the left rocker to
the left arm assembly .
STEP 3
On a clean flat surface, lay left arm assembly flat on the
ground. With mortise holes facing up, insert back assembly
into arm assembly.
NOTE: The top of the back is marked and should be placed
at the top of the chair.

Ver. 06.30.20