Panasonic FZ-VCN401 User manual

Rear Expansion Area
You can select from the following options.
FZ-VCN401 FZ-VCN402 FZ-VCN403
VGA Port / Serial Port / 2nd LAN
Port
Serial Port / USB 3.2 Gen 1 (Type-A) Port /
HDMI Port
USB 3.2 Gen 1 (Type-A) Port / USB 3.2 Gen 1 (Type-A) Port /
HDMI Port
Inserting an option to the rear expansion area
1. Turn off the computer and disconnect the AC adaptor.
IMPORTANT
lWe recommend that you turn off the computer completely the following.
1. Click (Start) - [Settings] - [System] - [Recovery].
2. Click [Restart now] in “Advanced startup”.
3. Click [Restart now] on the “We’ll restart your device so save your work” screen.
4. Click [Turn off your PC].
2. Remove the battery pack. ( Replacing the Battery Pack)
<When using second battery pack>
lRemove the second battery pack. ( Replacing the Battery Pack)
3. Slide the latch (A) to the arrow direction.
4. Open the cover (B).
5. Insert an option to the rear expansion area.
lIf an option has not been inserted, proceed to step 2.
1. Remove the screws (C) and pull the tab (D) to pull out an option.
Use the PH 1 (PH #1) screwdriver.

2. Insert an option until it securely fits the connector.
3. Tighten the screws (E) firmly.
Use the PH 1 (PH #1) screwdriver.
Use 2 screws.
Recommended tightening torque
0.45 N•m ± 0.05 N•m (4.5 kgf•cm ± 0.5 kgf•cm)
6. Close the cover until it clicks.
7. Insert the battery pack.