Panasonic KX-TPA50 User manual

Thank you for purchasing a Panasonic product.
Please read this installation manual before using the unit and
save it for future reference.
This unit is an additional handset compatible with the following
series of Panasonic SIP Cordless Phone:
KX-TGP500/KX-TGP550
You must register this handset with your base unit before it can
be used. This installation manual describes only the steps
needed to register and begin using the handset. For further
details, please read the base unit’s User Guide on the
Panasonic Web site at:
http://panasonic.net/pcc/support/sipphone/
Charge the batteries for about 6 hours before initial use.
Additional Cordless Handset
Installation Manual
Model No. KX-TPA50 B02

– 2 –
Accessory information
Supplied accessories
*1 Please read the replacement battery information section of the base
unit’s User Guide on the Panasonic Web site. See page 1 for
Panasonic URL.
*2 The handset cover comes attached to the handset.
Note:
LPlease read the additional/replacement accessory section of the base
unit’s User Guide on the Panasonic Web site. See page 1 for
Panasonic URL.
Setting up
Connections
Accessory item/Part number Quantity
Charger/PNLC1007ZB 1
AC adaptor/PNWE1P500B02 1
Rechargeable batteries*1 2
Handset cover*2 1
Belt clip/PNKE1029Z1 1
(220-240 V AC,
50/60 Hz)
Hooks

– 3 –
Note:
LUse only the supplied Panasonic AC adaptor PNWE1P500B02
(PQLV219E).
LThe AC adaptor must remain connected at all times. (It is normal for
the adaptor to feel warm during use.)
Battery installation/Battery charge
Important:
LUse the supplied rechargeable batteries. For replacement, we
recommend using the Panasonic rechargeable batteries noted in the
base unit’s User Guide on the Panasonic Web site. See page 1 for
Panasonic URL.
LWipe the battery ends (S, T) with a dry cloth.
LAvoid touching the battery ends (S, T) or the unit contacts.
LConfirm correct polarities (S, T).
LUSE ONLY Ni-MH batteries AAA (R03) size.
LDo NOT use Alkaline/Manganese/Ni-Cd batteries.
Charge for about 6 hours.
LWhen the batteries are fully charged, the charge indicator goes off.
Note:
LIf the batteries are fully charged, but the operating time seems to be
shorter, clean the battery ends (S, T) and the charge contacts with a
dry cloth and charge again.
Confirm
“Charging”is
displayed.
Rechargeable
Ni-MH ONLY
Charge indicator

– 4 –
Registering a handset to the base unit
1Base unit:
NKX-TGP500 series
Press and hold {ALL}for about 4 seconds until the STATUS
indicator flashes in red.
NKX-TGP550 series
Press and hold {ALL}for about 4 seconds until the registration tone
sounds and the STATUS indicator flashes in red.
LIf all registered handsets start ringing, press the same button to
stop. Then repeat this step.
LThe next step must be completed within 90 seconds.
2Handset:
{OK
L }
3Wait until “Enter Base PIN”is displayed. iEnter the base unit
PIN (default: “0000”). iPress {OK}, then wait until a long beep
sounds.
LIf you forget your PIN, contact your phone system dealer.
Note:
LIf an error tone sounds, or if _is still displayed, register the handset
according to the registering section of the base unit’s User Guide on
the Panasonic Web site. See page 1 for Panasonic URL.
Belt clip
NTo attach NTo remove

– 5 –
Wall mounting
1Drive the screws (not supplied) into the wall.
2Mount the charger (A), then slide it down (B) and to the right (C)
until it is secure.
Note:
LMake sure that the wall and the fixing method are strong enough to
support the weight of the unit.
For your safety
To prevent severe injury and loss of life/property, read this section carefully before
using the product to ensure proper and safe operation of your product.
WARNING
Power connection
LCompletely insert the AC adaptor/power plug into the power outlet. Failure to do
so may cause electric shock and/or excessive heat resulting in a fire.
LRegularly remove any dust, etc. from the AC adaptor/power plug by pulling it
from the power outlet, then wiping with a dry cloth. Accumulated dust may cause
an insulation defect from moisture, etc. resulting in a fire.
LUnplug the product from power outlets if it emits smoke, an abnormal smell, or
makes an unusual noise. These conditions can cause fire or electric shock.
Confirm that smoke has stopped emitting and contact your phone system dealer.
Installation
LTo prevent the risk of fire or electrical shock, do not expose the product to rain or
any type of moisture.
25 mm
Screws
A
B
C

– 6 –
LDo not place or use this product near automatically controlled devices such as
automatic doors and fire alarms. Radio waves emitted from this product may
cause such devices to malfunction resulting in an accident.
Operating safeguards
LThe use of excessive sound volume through earphones, headphones, or
headsets may cause hearing loss.
CAUTION
Installation and relocation
LThe AC adaptor is used as the main disconnect device. Ensure that the AC outlet
is installed near the product and is easily accessible.
Battery
LWe recommend using the supplied batteries or additional/replacement batteries
noted in the battery information section of the base unit’s User Guide on the
Panasonic Web site. See page 1 for Panasonic URL. USE ONLY rechargeable
Ni-MH batteries AAA (R03) size.
LDo not mix old and new batteries.
LDo not open or mutilate the batteries. Released electrolyte from the batteries is
corrosive and may cause burns or injury to the eyes or skin. The electrolyte is
toxic and may be harmful if swallowed.
LExercise care when handling the batteries. Do not allow conductive materials
such as rings, bracelets, or keys to touch the batteries, otherwise a short circuit
may cause the batteries and/or the conductive material to overheat and cause
burns.
LCharge the batteries provided with or identified for use with this product only, in
accordance with the instructions and limitations specified in this manual.
LOnly use a compatible charger to charge the batteries. Do not tamper with the
charger. Failure to follow these instructions may cause the batteries to swell or
explode.
Other information
LOperating the product near electrical appliances may cause interference. Move
away from the electrical appliances.
LUse only the power cord and batteries indicated in this manual. Do not dispose
of batteries in a fire. They may explode. Check with local codes for possible
special disposal instructions.

– 7 –
Routine care
LWipe the outer surface of the product with a soft moist cloth.
LDo not use benzine, thinner, or any abrasive powder.
Notice for product disposal, transfer, or return
LThis product can store your private/confidential information. To protect your
privacy/confidentiality, we recommend that you erase information such as
phonebook or caller list entries from the memory before you dispose of, transfer,
or return the product.
General information
LThis equipment is designed for use in the U.K.
LIn the event of problems, you should contact your service provider in the first
instance.
Declaration of Conformity:
LPanasonic System Networks Co., Ltd. declares that this equipment is in
compliance with the essential requirements and other relevant provisions of
Radio & Telecommunications Terminal Equipment (R&TTE) Directive 1999/5/
EC. Declarations of Conformity for the relevant Panasonic products described in
this manual are available for download by visiting:
http://www.doc.panasonic.de
Contact to Authorised Representative:
Panasonic Testing Centre
Panasonic Marketing Europe GmbH
Winsbergring 15, 22525 Hamburg, Germany
Information for Users on Collection and Disposal of Old Equipment and used
Batteries
These symbols (1, 2, 3) on the products, packaging, and/or accompanying
documents mean that used electrical and electronic products and batteries should
not be mixed with general household waste.
For proper treatment, recovery and recycling of old products and used batteries,
please take them to applicable collection points, in accordance with your national
legislation and the Directives 2002/96/EC and 2006/66/EC.
123

– 8 –
By disposing of these products and batteries correctly, you will help to save
valuable resources and prevent any potential negative effects on human health and
the environment which could otherwise arise from inappropriate waste handling.
For more information about collection and recycling of old products and batteries,
please contact your local municipality, your waste disposal service or the point of
sale where you purchased the items.
Penalties may be applicable for incorrect disposal of this waste, in accordance with
national legislation.
For business users in the European Union
If you wish to discard electrical and electronic equipment, please contact your
dealer or supplier for further information.
Information on Disposal in other Countries outside the European Union
These symbols (1, 2, 3) are only valid in the European Union. If you wish to
discard these items, please contact your local authorities or dealer and ask for the
correct method of disposal.
Note for the battery symbol
This symbol (2) might be used in combination with a chemical symbol (3). In this
case it complies with the requirement set by the Directive for the chemical involved.
Information on Disposal in other Countries outside the European Union
These symbols are only valid in the European Union. If you wish to discard these
items, please contact your local authorities or dealer and ask for the correct method
of disposal.

– 9 –
Notes

1-62, 4-chome, Minoshima, Hakata-ku, Fukuoka 812-8531, Japan
Copyright:
This material is copyrighted by Panasonic System Networks Co., Ltd.,
and may be reproduced for internal use only. All other reproduction, in
whole or in part, is prohibited without the written consent of Panasonic
System Networks Co., Ltd.
© Panasonic System Networks Co., Ltd. 2010
PNQX3051XA DM0810SY2012