Panasonic EP1285 User manual

EP1285 ORDER NO.0808U08C1
-1 -
MASSAGE LOUNGER
EP1285
USA
SPECIFICATIONS
©2008 Matsushita Electric Works, Ltd.
All rights reserved. Unauthorized copying
and distribution is a violation of law.

EP1285 ORDER NO.0808U08C1
-2 -
CONTENTS Page
1 COMPONENTS IDENTIFICATION…………………………………………………………………………………………………………………………3
2 TURNING ON THE POWER………………………………………………………………………………………………………………………………5
3 REQUIRED TOOLS…………………………………………………………………………………………………………………………………………6
4 DISPLAY METHOD OF MASSARG BLOCK TOTAL USE TIME AND OPERATION TIME…………………………………………………………7
5 DISASSEMBLY………………………………………………………………………………………………………………………………………………10
6 CHECKING AFTER REPAIR……………………………………………………………………………………………………………………………41
7 CHECKING…………………………………………………………………………………………………………………………………………………42
8 CHECING THE AIR BAG PRESSURE……………………………………………………………………………………………………………………46
9 EXPLODED VIEW…………………………………………………………………………………………………………………………………………48
10 REPLACEMENT PARTS LIST……………………………………………………………………………………………………………………………54

EP1285 ORDER NO.0808U08C1
-3 -
1. COMPONENTS IDENTIFICATION
1.1. MASSAGE LOUNGER

EP1285 ORDER NO.0808U08C1
-4 -
1.2. CONTROLLER

EP1285 ORDER NO.0808U08C1
-5 -
2. TURNING ON THE POWER
1. Plug the power plug into the power socket.
2. Turn the lock switch to the open position.
3. Turn on the power switch on the back of the unit.
･When the operating lock switch is pointing toward ‘lock’, the power switch cannot be moved to the ‘on’ position.
Timer
When the on/off button is pushed, a timer begins to prevent overuse. After approximately 15 minutes, time expires and the
massage wheel goes into storage position.
After each use.
･Be sure to turn the power switch to ‘off’.
･To prevent children from using this unit, lock the power switch by moving the operating lock
switch to the ‘lock’ position.
･As a further caution, unplug the power cord from the power socket after each use.

EP1285 ORDER NO.0808U08C1
-6 -
3. REQUIRED TOOLS

EP1285 ORDER NO.0808U08C1
-7 -
4. DISPLAY METHOD OF MASSAGE BLOCK TOTAL USE TIME
AND OPERATION TIME
4.1. Total use time
1. Close the Cover of the Controller.
2. While pushing the Up/down buttons of neck roller position, turn on the Switch of the Power source switch block. Keep pushing
the Buttons more than approximately three seconds.(OFF/ON button lights.)
3. The total use time is indicated in the Screen of the Controller.
* If the total use time is less than five hours, no indications appear.If the total use time is less than ten hours, one LED lights,
which means five hours.
* It can indicate up to 5,115 hours.
How to read the total use time by the Controller
Sum the LEDs, which light.
For example, if 5, 40, and 160 light,
5 + 40 + 160 = 205 hours

EP1285 ORDER NO.0808U08C1
-8 -
4.2. Display method of operation time
While in the display method of Massage block total use time, push the buttons on the Controller to indicate the accumulative
usage time of each operations.
* Open the Cover of the Controller.
* Indications are the same of those of the Total use time.
* OFF/ON lamp does not go off.
4.3. Adjustment of Packing storage position
1. Open the Cover of the Controller.
2. While pushing the Knead and the Full roll buttons, turn on the Switch of the Power source switch block. Keep pushing the
Buttons more than approximately three seconds. (OFF/ON button lights.)
3. Push the button of Neck roller position up.
4. Fold the Reclining.
* After the storage is done, the OFF/ON lamp goes off.
Caution
The Massage mechanism block stops approximately 9.84 in. (25cm) from the bottom of the Rear frame when in the
storage mode.

EP1285 ORDER NO.0808U08C1
-9 -
How to fold the Massage chair
1. ①Turn off the switch. ②Lock it. ③Pull
off the Plug from the power source and
also from the Power source switch box.
2. Remove the Rear cushion and the
Headrest from the Massage chair.
3. Fold the Back rest.
①Insert the Screwdriver to top of
the Stopper hole of the Rear
cover for approx. 4cm till it hits
the Stopper.
②Push down the Screwdriver
diagonally for approx. 1 in.
(2.5cm) to release the Stopper.
③Pull off the Screwdriver when
the Back rest starts falling.
* Be careful not to have the Controller cord or
Power cord hooked between the Back rest and
the Seat.

EP1285 ORDER NO.0808U08C1
-10 -
5 DISASSEMBLY
5.1. Disassembly of Headrest, Back cushion, and Armrests
1. Unzip the Zippers, and remove the Headrest and
the Back cushion.
2. Peel off the Velcro to remove the Controller cord from
the Armrest.
3.Peel off the Velcro, pull out the tip of the Zippers, and
unzip them.