Panasonic NS700 Operating instructions

Page 1
Panasonic NS-700
Program an NT Type phone
Check that DHCP is On:
Power phone on
When yo see SETUP in the LCD, Press the b tton below SETUP
Use the navigation disk and select Network
Press the b tton below ENTER
Look at the top of the LCD and be s re DHCP is Enable.
If it isn't, se the Navigation Disk to select Enable.
Press the b tton below EXIT
Press the b tton below EXIT
If yo see "Data's changed!" STORE?
Select YES
------------------------------------------------------------------
Program the phone to reach the PBX
Power the phone down (by npl gging it from the wall, for 15 seconds.
Then, Power the phone back on
When yo see SETUP in the LCD, press the b tton below SETUP
Use the Navigation Disk and select PBX
Press the b tton below ENTER
Select PBX IP Address
Press the b tton below ENTER
Select Primary PBX
Press the b tton below ENTER
Enter this IP Address 192.168.2.159

Page 2
Press the b tton below ENTER
Press the b tton below EXIT
Press the b tton below EXIT
Press the b tton below EXIT
The phone will now try to log into yo r PBX.