PB TEEN Beadboard Bedside Table User manual

1 of 3
www.pbteen.com
Beadboard Bedside Table
Pre-assembly:
•Please read all instructions before starting to assemble.
•Two-person is recommended during assembly.
•Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or
hardware.
Parts Included:
A – Top – 1 pc B – Frame Leg – 2 pcs C – Shelf – 2 pcs
Hardware Included:
D – Allen Key – 1 pc E – Hex Bolt – 8 pcs F – Phillip Head Screw – 8 pcs
Tool Required:
Phillips Head Screwdriver ( not included)
Instructions:
1. Put Top (A) on a soft, scratch-free surface, such as a carpet or rub. Slowly pull out the drawer as
shown below.

2 of 3
www.pbteen.com
2. Sit Top (A) on its back, align pre-drilled holes in Frame Leg (B) with exposed wooden dowels on
side panel of Top (A); Insert Hex Bolt (E) through pre-drilled holes in drawer box frame into pre-
drilled holes in Frame Leg (B) as shown below, loosely tighten with Allen Key (D). Repeat for rest
3 Hex Bolts (E).
3. Slide Shelves (C) into grooves in Frame Leg (B), insert Philips Head Screws (F) into predrilled
holes at the bottom of Shelves (C). Tighten Shelves (C) to Frame Leg (B) with Phillip Head
Screwdriver, as shown below.
4. Assemble another Frame Leg (B) with Top (A) and Shelves (C). Align pre-drilled holes in Frame
Leg (B) with exposed wooden dowels on side panel of Top (A); make sure Shelves (C) goes into
grooves in Frame Leg (B) at the same time. Insert Hex Bolt (E) through pre-drilled holes in drawer
box frame into pre-drilled holes in Frame Leg (B), repeat for rest 3 Hex Bolts (E). Tighten all Hex
Bolts (E) on both Frame Legs (B). Insert Philips Head Screws (F) into predrilled holes at the
bottom of Shelves (C). Tighten Shelves (C) to Frame Leg (B) with Phillip Head Screwdriver, as
shown below.

3 of 3
www.pbteen.com
5. Stand up this assembled Bedside Table. Re-insert the drawers.
6. Adjust the recessed levelers underneath the legs to make sure the whole assembling balance.
7. Hardware should be checked periodically for tightness.
Care Instructions:
•Avoid direct sunlight and excessive temperatures.
•Dust often using a clean, soft, dry and lint-free cloth.
•Slightly moisten cloth with water. A damp cloth holds dust and prevents scratching.
•Waxing is not recommended on lacquered finish.