PEQUEA PLANTER
Pequea Planter LLC
561 White Horse Rd.
Gap, PA 17527
717-442-4406
Regular Frame Coulter Operators Manual
Remove chain (A), shaft (B), and sprocket (C). Remove bolts (D)
and back row unit away from planter frame. Remove angles (E)
and use original U-bolts (F) to mount coulter frame (G).
Re-attach row unit (H), sprocket (C), shaft (B), and chain (A).
Attach blade (I) to
hub (J) with 3/8"
bolts and nuts.
Align blade (I) with
seed disk (K) with
shim washers (L),
using more or less
on each side.
Fasten with 5/8"
x 8" bolt (M) and
locknut (N). Tighten
nut then tap on bolt
(M) with hammer to
seat bearings.
It is recommended to use down pressure springs (O) for no-
till. Attach as shown in picture with inside springs fastened for
conventional ground. Fasten all springs for no-till. Use clip pin
(P) for easy adjusting.
PEQUEA PLANTER
Regular No-Till Coulter Installation Instructions
E
D
FD
E
BC
D
MN
LL
J
I
R
A
Operating Instructions
MAINTENANCE INSTRUCTIONS
Occasionally, check coulter
blade diameter, replace
if less than 14". When
replacing blade, check
bearings. Bearings may not
last 2 sets of blades.
For best results, coulter blade
should not run much deeper
than seed disk. Start in
shallow position as shown in
diagram (R), than adjust down
to correct depth.
If coulter blade does not
go deep enough it, may be
necessary to add weight to
planter frame.
I
J
G
OOH
K
P
