Percussion Play Sansa Rimba User manual

1. Attach the steel leg to the
base of the instrument with
the M8 Nyloc Nuts and 2 part
security caps. (1.1) (See
Assembly Guide)
Wall Fixed
Ground Surface
KS1,2
KS1 –700mm
KS2 –850mm
Installation Instructions
2. Attach Wall Fixing posts to
legs(1.2) (See Ground Fix Post
Installation Sheet)
(1.1)
Instrument
Components:
6. Attach the 1 pair of beater
to the saddle strap on the leg.
(1.3)
Wall Fix
Components:
(1.3)
14 Kg
Pair Small Red
Beaters X1
Sansa Rimba
Page 1 of 2
Weight of heaviest part 10kg (Sansa Rimba)
BS EN 1176
Metric Conversion:
700mm/ 28”
850mm/ 33”
1.5m/ 59”
M8 Nyloc Nut
x4
M6x20 Security Screw
x2
M6 Saddle Strap
x1
2 Part Cover Cap
x4
Wall Fixings/ Anchors
not supplied
2 Part Cover Cap
x4
3.Mark hole locations (X4)
using the pre drilled holes in
square plate.
4. Drill hole locations (X4)
according to your chosen
fixings
(frame fixings, wall bolts or
chemical anchors) depending
of the structure of the wall.
(Not Supplied)
5. Fix through Plate with
suitable fixings (not supplied)
in correct orientation and
height for intended Key stage.
Cover Fixings with 2 Part Caps
supplied
Spares available from
percussionplay.com or from your
local distributor
Install Instrument
with 1.5m free space
(from widest point)
around it.
1.5m
1.5m

COMPONENTS LIST:
2 Part Cover Cap X8
Saddle Strap X1
M6x20 Pin torx X2
M8 Nyloc nut X4
Wall Fixed
Assembly Guide PPCADE
(1.1)
Wall Fix
Components: 14 Kg
Pair Small Red
Beaters X1
Sansa Rimba
Page 2 of 2
BS EN 1176
Thread Lock Solution
Required (Not Supplied)
Thread Lock Solution
Required (Not Supplied)
Instrument
Components:
M8 Nyloc Nut
x4
M6x20 Security Screw
x2
M6 Saddle Strap
x1
2 Part Cover Cap
x4
TX 30 Driver Bit
x1
Tools:
Wall Fixings/ Anchors
not supplied
2 Part Cover Cap
x4 Spares available from
percussionplay.com or from your
local distributor