Pet Gear DELUXE SOFT STEP 4 User manual

To see our full line of products, visit us online at: www.petgearinc.com
CUSTOMER SERVICE HELP DESK
[email protected]
Toll-Free 877-752-9123 - Eastern Standard Time 8am-3pm, Monday through Friday
For The ON-THE-GO Pet™
INSTRUCTION MANUAL
DELUXE SOFT STEP 4
PG9740SOC

DELUXE SOFT STEP 4 • PG9740SOC
2
PARTS LIST
Check that you have all the parts shown BEFORE assembling your product.
If any parts are missing, call Customer Service.
Dowels
Risers
Top Stair
with Straight Edge
Left Panel Right Panel
AB
C
E
D
with Curved Side
Middle and Bottom
Stairs
F
Deluxe Soft Step Cover
G

DELUXE SOFT STEP 4 • PG9740SOC 3
ASSEMBLY INSTRUCTIONS
Step 1
With rubber grippers on the bottom, place right
panel, part (B) on oor with PET GEAR Logo
facing the oor and insert top stair, part (E).
Keep the STRAIGHT EDGE toward the back and
rug facing the top. Make sure there are no gaps
between parts after inserted. (If inserting part
is difcult put a little dish soap on doweled end
before inserting.)
Step 2
Insert riser, part (C).
Make sure there are no gaps between parts
after inserting.
Step 3
Insert second stair, part (F). Note the CURVED
SIDE direction. Make sure there are no gaps
between parts after inserting.
Step 4
Insert riser, part (C). Make sure there are no
gaps between parts after inserting.
C
B
E
Straight Edge
Make sure
rubber
grippers
are on the
bottom.
F
B
C
Curved
Side

DELUXE SOFT STEP 4 • PG9740SOC
4
ASSEMBLY INSTRUCTIONS
Step 5
Insert third stair, part (F). Note the CURVED SIDE
direction. Make sure there are no gaps between parts
after inserting.
Step 6
Insert riser, part (C). Make sure there are no gaps
between parts after inserting.
Step 7
Insert bottom stair, part (F). Note the CURVED SIDE
direction. Make sure there are no gaps between parts
after inserting.
F
Curved
Side
F
C
F
Curved
Side

5
DELUXE SOFT STEP 4 • PG9740SOC
ASSEMBLY INSTRUCTIONS
Step 8
Insert the nal riser, part (C). Make sure there are no gaps
between parts after inserting.
Step 9
Insert dowels, part (D). Make sure there are no gaps between
parts after inserting.
Step 10
Attach left panel, part (A). Align all holes before pushing
panel down. Make sure there are no gaps between parts
after inserting.
F
C
D
D
D
A