Philips Dynalite DDLE802 User manual

www.lighting.philips.com/dynalite
Leading Edge
Dimmer Controller
Installation Instructions
Instructions d’installation
Installationsanweisungen
Instrucciones de instalación
Istruzioni per l’installazione
Installatie-instructies
インストー ル 手 順
安装指示
DDLE802
RJ12
211 mm (8.31 in)
94 mm (3.70 in)
75 mm (2.95 in)
150 mm (5.90 in)
45 mm
(1.77 in)
45 mm
(1.77 in)
1
40° C (104° F)
0° C (32° F)
≤
90%
IEC Pollution Degree II If ventilation is restricted, apply load de-rating to outputs.
Devices must be installed in an
approved enclosure by a qualied
electrician in accordance with all
national and local electrical and
construction codes and regulations.
Les appareils doivent être installés dans un lieu jugé
apte, par un électricien qualié et conformément
aux règles et normes locales et nationales en
matière d’électricité et de construction.
Die Geräte müssen von einem geprüften Elektriker
entsprechend allen nationalen und lokalen Elektro
– und Bauvorschriften in einem zugelassenen
Gehäuse installiert werden.
Los dispositivos se deben instalar en un recinto
aprobado por un electricista cualicado de
acuerdo a todos los reglamentos eléctricos y de
construcción locales y nacionales pertinentes.
I dispositivi devono essere installati da un
elettricista qualicato in un luogo approvato, in
conformità a tutti gli standard e le norme nazionali
e locali vigenti in materia di impianti elettrici e
costruzioni edilizie.
Apparaten moeten door een erkende elektricien
worden geïnstalleerd in een goedgekeurde
behuizing in overeenstemming met alle nationale
en lokale elektriciteits – en bouwvoorschriften
en wetgeving.
デバイスを取り付ける際は、資格のある電気技師に依頼
し、電気と建設に関する国および地域のすべての法令に
従って、認可されている筐体内に取り付けてください。
根据国家/地区及当地的电气与建筑规范和法规，该设
备必须由有资质的电工安装在经批准的外罩内。

N
N
L
CH1
µP
T 6.3 A M205
T 6.3 A M205
NCH2
CH3
CH4
CH5
CH6
CH7
CH8
N
N
N
N
N
N
L
L
L
L
L
L
L
L
+12 V
D +
D -
GND
SHLD
AUX
RJ12
DyNet
RS-485
DMX Rx
T 6.3 A M205
T 6.3 A M205
230 V
16 A
12 V 120 mA
0.56 Nm
5 Lb-in
≤2.5 mm2
12+ AWG
SHLD GND D+ D- +12 V AUX
SHLD D+ GND D-
+12 V AUX
DyNet RS-485
GND AUX
<20 m
RJ12
≤ 2 A
43
DyNet RS-485
65
SHLD GND D+ D- +12V AUX
L N CH1 NCH2 NCH3 NCH4 NCH5 NCH6 NCH7 NCH8 N
•
RJ12
≤ 16 A≤ 2 A/CH
≤5 mm2
10+ AWG
0.62 Nm
5.5 Lb-in
2
Philips Dynalite
www.lighting.philips.com/dynalite
© 2018 Philips Lighting. All rights reserved.
Apply de-rating for electronic and LED loads.
The manufacturer is not responsible for dimmable lamp selection. Each lamp/dimmer combination must be tested for compatibility prior to installation.
Professional dimmers rated > 1000 W are out of scope of EN 61000-3-2.
IEC Overvoltage Category III