Philips Dynalite DDLE801 User manual

DDLE801
RJ12 215 mm (8.46 in)
93 mm (3.66 in)
64 mm (2.52 in)
45 mm
(1.77 in)
45 mm
(1.77 in)
1
www.lighting.philips.com/dynalite
Leading Edge
Dimmer Controller
Installation Instructions
Instructions d’installation
Installationsanweisungen
Instrucciones de instalación
Istruzioni per l’installazione
Installatie-instructies
インストー ル 手 順
安装指示
40° C (104° F)
-5° C (23° F)
≤
90%
IEC Pollution Degree II If ventilation is restricted, apply load de-rating to outputs.
Devices must be installed in an
approved enclosure by a qualied
electrician in accordance with all
national and local electrical and
construction codes and regulations.
Les appareils doivent être installés dans un lieu jugé
apte, par un électricien qualié et conformément
aux règles et normes locales et nationales en
matière d’électricité et de construction.
Die Geräte müssen von einem geprüften Elektriker
entsprechend allen nationalen und lokalen Elektro
– und Bauvorschriften in einem zugelassenen
Gehäuse installiert werden.
Los dispositivos se deben instalar en un recinto
aprobado por un electricista cualicado de
acuerdo a todos los reglamentos eléctricos y de
construcción locales y nacionales pertinentes.
I dispositivi devono essere installati da un
elettricista qualicato in un luogo approvato, in
conformità a tutti gli standard e le norme nazionali
e locali vigenti in materia di impianti elettrici e
costruzioni edilizie.
Apparaten moeten door een erkende elektricien
worden geïnstalleerd in een goedgekeurde
behuizing in overeenstemming met alle nationale
en lokale elektriciteits – en bouwvoorschriften
en wetgeving.
デバイスを取り付ける際は、資格のある電気技師に依頼
し、電気と建設に関する国および地域のすべての法令に
従って、認可されている筐体内に取り付けてください。
根据国家/地区及当地的电气与建筑规范和法规，该设
备必须由有资质的电工安装在经批准的外罩内。

E
N
N
L
µP
T 6.3A M205
T 6.3A M205
N
N
N
N
N
N
N
L
L
L
L
L
L
L
L
+12 V
D +
D -
GND
SHLD
AUX
DyNet
RS-485
DMX Rx
2 x RJ12
CH1
CH2
CH3
CH4
CH5
CH6
CH7
CH8
100-240 V
10 A
12 V 200 mA
0.56 Nm
5 Lb-in
≤2.5 mm2
12+ AWG
SHLD GND D+ D- +12 V AUX
SHLD D+ GND D-
+12 V AUX
DyNet RS-485
≤ 2 A
GND AUX
<20 m
43
DyNet RS-485
65
L
N L
N
CH1
L N
CH2
L N
CH3
L N
CH4
L N
CH5
L N
CH6
L N
CH7
L N
CH8
≤ 8 A≤ 1 A/CH
≤ 800W100W/CHLED
INCANDESCENT
0.62 Nm
5.5 Lb-in
≤5 mm2
10+ AWG
2
Philips Dynalite
www.lighting.philips.com/dynalite
© 2018 Philips Lighting. All rights reserved.
The manufacturer is not responsible for dimmable lamp selection. Each lamp/dimmer combination must be tested for compatibility prior to installation.
Installation of a home and building automation and control system shall comply with HD 60364-4-41. The temperature limits and current-carrying capacities for
the communication wires specied in HD 384.5.523 shall not be exceeded.
Professional dimmers rated > 1000 W are out of scope of EN 61000-3-2.
IEC Overvoltage Category III