Philips 9290 014 61062 User manual

Wireless Controller
Wireless Controller
Wireless
9290 014 61062
1. Communication distance: 15-30M
Toggle switch
Socket for software update
Battery
Battery
Remote controller
Rear plate
Magnet end cap
Remove the battery gently with your hand. Put the new battery into the lower part of the left spring plate first and pushing it from the
right side for installing
Installation guide
Parts description
Battery exchanged
For detailed information of APP , please refer to ：
www.beesmart.com.hk:88
12 NC
9290 014 61062
The information provided herein is subject to change, without notice. Signify does not give any representation or warranty
as to the accuracy or completeness of the information included herein and shall not be liable for any action in reliance
thereon. The information presented in this document is not intended as any commercial offer and does not form part of
any quotation or contract, unless otherwise agreed by Signify.Philips and the Philips Shield Emblem are registered trademarks
of Koninklijke Philips N.V. All other trademarks are owned by Signify Holding or their respective owners.
www.philips.com/lighting
2018 Signify Holding, IBRS 10461, 5600VB, NL. All rights reserved.

02 Select One Option
05 Input MAC CODE
New product can be located after
successful adding
Network overtime or searching failure
warning,please check again
03 scan
06 Select Zone
01 Add Product
04 Search
07 Successful Adding 08 Adding Failure
Product configuration
Check Gateway and
compatibility
enviromnent
1
Check product power-on condition
2
Retry after few seconds
3
First to dial down the toggle switch so that the controller is in normal remote-control mode
1 . ① key is group 1, press it to control those lamps in the group
Dial up the toggle switch on the back, press 6 key until the LED is flicker under the ⑥ key, which means the remote controller has
been restored to original state
1 . Searching and adding new equipment in APP , Gateway open the Zigbee mesh network
2 . Turning the ① key slide switch on the back to the up, press ⑤ key on the front of remote and then the LED will flicker and
the remote search network. The LEDs will go out immediately after flashed six times. It mean the equipment is into
the mesh network
4 . ④ key is tunable white, press it to switch 2700k --3500K-4000K-5000K-6000K on the lamp
2 . ② key is group 2, press it to control those lamps in the group
5 . ⑤ key is RGBW, press it to switch red-green-blue-cyan-Purple on the lamp
7 . ⑦ key is Is dim up, keep pressing the key to dim up gradually. When luminaire is turned off,
it will light up automatically
3 . ③ key is group 3, press it to control those lamps in the group
6 . ⑥ key is On/Off keys, press it to control the lamp
8 . key is Dim down,, keep pressing the key to Dim down gradually. It will turn on when the state
is off at the lamp
⑧
Keys instruction
Accessing Zigbee mesh network
Turn the slide switch downward on the back first
Press ①、② and ③ keys which are equipment group and then LED under button will brighten up for a second.
Press ④、⑤、⑥、⑦ and ⑧ keys to control equipment and dimming amp
Control