Philips HP4680/00 User manual

Register your product and get support at
www.philips.com/welcome Styler
HP4680/00
EN User manual

g
l
m
n
o
p
i
rq
s
e
f
h
d
kj
a
b
c

English
Congratulations on your purchase, and welcome to Philips! To fully
benet from the support that Philips offers, register your product at
www.philips.com/welcome.
1 Important
Read this user manual carefully before you use the appliance and keep it
for future reference.
WARNING: Do not use this appliance near water.
•
When the appliance is used in a bathroom, unplug it after use since• the proximity of water presents a risk, even when the appliance is
switched off.
WARNING: Do not use this appliance near bathtubs,
• showers, basins or other vessels containing water.
• Before you connect the appliance, ensure that the
voltage indicated on the appliance corresponds to the
local power voltage.
Do not use the appliance for any other purpose than described in
• this manual.
Only use the appliance on dry hair. Do not use the appliance on
• articial hair.
When the appliance is connected to the power, never leave it
• unattended.
Always unplug the appliance after use.
•
When the appliance is hot, keep it on a heat-resistant surface and• never cover the appliance with anything, such as a towel or clothing.
Never use any accessories or parts from other manufacturers or that
• Philips does not specically recommend. If you use such accessories
or parts, your guarantee becomes invalid.
Keep the hot surfaces of the appliance away from your skin.
•
Do not wind the mains cord round the appliance.•
If you use the appliance on color-treated hair, the straightening• plates/curling tongs may stain.

If the mains cord is damaged, you must have it replaced by Philips, a• service centre authorised by Philips or similarly qualied persons in
order to avoid a hazard.
This appliance is not intended for use by persons (including children)
• with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do not play with
• the appliance.
For additional protection, we advise you to install a residual current
• device (RCD) in the electrical circuit that supplies the bathroom.This
RCD must have a rated residual operating current not higher than
30mA. Ask your installer for advice.
Electromagnetic elds (EMF)
This appliance complies with all standards regarding electromagnetic
elds (EMF). If handled properly and according to the instructions in this
user manual, the appliance is safe to use based on scientic evidence
available today.
Environment
Do not throw away the appliance with the normal household
waste at the end of its life, but hand it in an ofcial collection
point for recycling. By doing this, you help to preserve the
environment.
2 Style your hair
Caution: If the appliance is used on young children’s hair, it must be
operated by a responsible adult. Older children must be instructed and
supervised when they use the appliance. Keep the appliance out of the
reach of young children.

Note: Do not change the attachments or styler when the appliance is
heating up or when it is hot. Let the appliance heat up for 5-15 minutes
for a perfect result. Do not pull at the curler when you unwind the
section, otherwise you would straighten the curl.
Select a suitable attachment and styler for the hairstyle you want.
Hairstyle Attachment and Styler
Large rounded
curls Large curling attachment ( )
Triangular curls Triangle attachment ( )
Large ringlets Large curling attachment ( ) and Slide-on spiral ( )
Crimps Crimping/straightening attachment ( ) and
Crimping/straightening plates ( ) with the curved
sides ( ) pointing towards each other
Straight sleek
style and icks Crimping/straightening attachment ( ) and
Crimping/straightening plates ( ) with the at
sides ( ) pointing towards each other
Before you style your hair:
1Slide a suitable attachment onto the handle ( ) and turn the ring
() to lock it ( ).
To disconnect the attachment, unlock it (• ) and pull it off.
2Slide crimping/straightening plates ( ) onto the attachment ( ).
To remove the plate, grab the cool tips (• ) and pull it off.
3Place the appliance with the support ( ) outwards on a heat-
resistant surface.
4Connect the plug to a power supply socket.
The power-on indicator (») lights up.
When the appliance is ready for use, the ready indicator (»)
changes color.