Philips HP8602/00 User manual

Register your product and get support at
www.philips.com/welcome HP8602
EN User manual

HP8602

a
c
d
e
g
b
f
h
i

10 sec.

English
1 Congratulations
Congratulations on your purchase, and welcome to Philips! To fully
benet from the support that Philips offers, register your product at
www.philips.com/welcome.
2 Introduction
CurlCeramic curler with 16 mm barrel helps you easily achieve vivid,
bouncy curls and ringlets for joyful and young look. Protective ceramic
coating ensures even heat distribution and less hair damage.Top
temperature of 190 ºC guarantees optimal result while minimizing hair
damage.We hope you will enjoy using your CurlCeramic.
3 Important
Read this user manual carefully before you use the appliance and save it
for future reference.
• This appliance can be used by children
aged from 8 years and above and persons
with reduced physical, sensory or mental
capabilities or lack of experience and
knowledge if they have been given
supervision or instruction concerning
use of the appliance in a safe way and
understand the hazards involved. Children
shall not play with the appliance. Cleaning

and user maintenance shall not be made
by children without supervision.
• Children should be supervised to ensure
that they do not play with the appliance.
• If the mains cord is damaged, you must
have it repalced by Philips, a service centre
authorized by Philips or similarly qualied
persons in order to avoid a hazard.
• WARNING: Keep this appliance
away from water. Do not use it
near or over water contained in
baths, washbasins, sinks etc.When you
use the appliance in a bathroom, unplug
it after use.The proximity of water
presents a risk, even when the appliance is
switched off.
• Check if the voltage indicated on the appliance corresponds to the
local mains voltage before you connect the appliance.
• Check the condition of the mains cord regularly. Do not use the
appliance if the plug, the cord or the appliance itself is damaged.
• For additional protection, we advise you
to install a residual current device (RCD)
in the electrical circuit that supplies the
bathroom.This RCD must have a rated

residual operating current not higher than
30mA. Ask your installer for advice.
• The barrel of this appliance becomes hot during use. Prevent contact
with the skin.
• Prevent the mains cord from coming into contact with the hot parts
of the appliance.
• Only use the appliance on dry hair.
• Always unplug the appliance after use.
• Wait until the appliance has cooled down before you store it.
• Keep the barrel clean and free of dust and styling products such as
mousse, spray and gel. Never use the appliance in combination with
styling products.
• Always return the appliance to a service centre authorized by Philips
for examination or repair. Repair by unqualied people could cause
an extremely hazardous situation for the user.
• The barrel has a ceramic coating.This coating slowly wears away
over time.This does not affect the performance of the appliance.
• Keep the appliance away from ammable objects and materials
when it is switched on.
• Never cover the appliance with anything (e.g. a towel or clothing)
when it is hot.
• Never leave the appliance unattended when it is plugged in.
• If the appliance is used on colour-treated hair, the barrel may stain.
• This appliance is extremely hot, pay full attention when using this appliance.
• Only hold the handle while the unit plugged in, other parts are hot.
• Before use it in articial hair, always consult their distributor.
• Do not operate the appliance with wet hands.
• Always place the appliance with the stand on a heat-resistance, stable
at surface. The hot barrel should never touch the surface or other
ammable material.

Electromagnetic elds (EMF)
This appliance complies with all standards regarding electromagnetic
elds (EMF). If handled properly and according to the instructions in this
user manual, the appliance is safe to use based on scientic evidence
available today.
Environment
Do not throw away the appliance with the normal household
waste at the end of its life, but hand it in an ofcial collection
point for recycling. By doing this, you help to preserve the
environment.
4 Curl your hair
1 Connect the plug to a power supply socket.
2 Slide the on/off switch ( ) to Ito switch on the appliance.
» The power-on indicator ( ) lights up and starts blinking.
» When the appliance is ready for use, the indicator ( ) stops
blinking.
3 Before you start curling, comb your hair and divide your hair into
small sections. Press the lever (e) and place a section of hair
between the barrel (b) and clip (c).
4 Close the clip by releasing the lever and slide the barrel to the hair tip.
5 Hold the cool tip (a) and the handle ( ) of the curling iron, and
then wind the section of hair around the barrel from tip to root by
rotating the curler.
6 Hold the curling iron in the position for max. 10 seconds.
Note
•Do not pull at the curler when you unwind the section, otherwise you would
straighten the curl.

7 Unwind the section of hair until you can open the clip again with the lever.
8 Release the curled hair.
To curl the rest of your hair, repeat steps 3 to 8.
You may curl your hair both from inside out or from outside in as you like.
After use:
1 Switch off the appliance and unplug it.
2 Place it on the resting stand (d) until it cools down.To place it on a
heat-resistant surface is highly recommended.
3 Remove hairs and dust from the barrel and clip.
4 Clean the barrel and the clip with damp cloth.
5 Keep it in a safe and dry place, free of dust.You can also hang it with
the hanging loop ( ).
5 Guarantee and service
If you need information or if you have a problem, please visit the Philips
website at www.philips.com or contact the Philips Customer Care
Centre in your country (you nd its phone number in the worldwide
guarantee leaet). If there is no Consumer Care Centre in your country,
go to your local Philips dealer or contact the Service Department of
Philips Domestic Appliances and Personal Care BV.

6 Troubleshooting
If problems should arise with your curler and you cannot solve them
with the information below, please contact the nearest Philips service
centre or the Philips Customer Care Centre in your country.
Problem Cause Solution
The appliance
does not work
at all.
The power socket to
which the appliance has
been connected may
not live.
Ensure the socket is live.
The mains cord of
the appliance may be
damaged.
If the mains cord is
damaged, you must
have it replaced by
Philips, a service centre
authorised by Philips
or similarly qualied
persons in order to
avoid a hazard.

All registered and unregistered trademarks are property of their
respective owners.
© 2012 Koninklijke Philips Electronics N.V.
All rights reserved.
3140 035 28192