Philips HR1652/91 User manual

HR1652, HR1651, HR1650

1

HR1652, HR1651, HR1650
ENGLISH 6
 13
 20
 27
 34
 41
 48
 55
 62
 69
 76
 83
 90
 97
 104
 111

6
Introduction
Congratulations on your purchase and welcome to Philips! To fully benet from the support that
Philips offers, register your product at www.philips.com/welcome.
General description (Fig. 1)
Speed ring
BOn/off button
CTurbo button
DMotor unit
ERelease button
FBlender bar
GProtection cap
Whisk and milk foamer (HR1651 only)
HWhisk and milk foamer coupling unit
IWhisk
JMilk foamer
Round beaker
Round beaker lid
LRound beaker
Medium chopper (HR1652 only)
MChopper lid
NIce-crushing blade unit
OBlade unit
PChopper bowl
Important
Read this user manual carefully before you use the appliance and save it for future reference.
Danger
- Never immerse the motor unit in water or any other liquid, nor rinse it under the tap. Only use
a moist cloth to clean the motor unit.
Warning
- Check if the voltage indicated on the appliance corresponds to the local mains voltage before
you connect the appliance.
- Do not use the appliance if the plug, the mains cord or other parts are damaged.
- If the mains cord is damaged, you must have it replaced by Philips, a service centre authorised by
Philips or similarly qualied persons in order to avoid a hazard.
- Avoid touching the blades, especially when the blender bar is attached to the motor unit.
The blades are very sharp.
- Never use the chopper blade unit without the chopper bowl.
- If the appliance is damaged, always have it replaced with one of the original type, otherwise your
guarantee is no longer valid.
- This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Do not allow children to use the appliance without supervision.
- Children should be supervised to ensure that they do not play with the appliance.
- Never let the appliance operate unattended.
- Be careful to avoid splashing when you process hot ingredients.
ENGLISH

- None of the accessories are suitable for use in the microwave.
- Do not touch the blades, especially when the appliance is plugged in.The blades are very sharp.
- If the blades get stuck, unplug the appliance before you remove the ingredients that block the
blades.
Caution
- Switch off the appliance and disconnect it from the mains before you assemble, disassemble,
store and clean it.
- Never use any accessories or parts from other manufacturers or that Philips does
not specically recommend. If you use such accessories or parts, your guarantee becomes
invalid.
- This appliance is intended for household use only. If the appliance is used improperly or for
professional or semi-professional purposes or if it is not used according to the instructions in
the user manual, the guarantee becomes invalid and Philips refuses any liability for damage
caused.
- Keep the motor unit away from heat, re, moisture and dirt.
- Never ll the beaker or the chopper bowl with ingredients that are hotter than 80°C/175°F.
- This appliance is intended for household use only.
- Do not exceed the quantities and processing times indicated in the tables.
- Do not process more than 1 batch without interruption. Let the appliance cool down for 5
minutes before you continue processing.
- Noise level: Lc = 79 dB(A).

This Philips appliance complies with all standards regarding electromagnetic elds (EMF). If handled
properly and according to the instructions in this user manual, the appliance is safe to use based on
scientic evidence available today.

Thoroughly clean the parts that come into contact with food before you use the appliance for the
rst time (see chapter ‘Cleaning’).
Preparing for use
1 Let hot ingredients cool down before you chop them, blend them or pour them into the
beaker (max. temperature 80°C/175°F).
2 Cut large ingredients into pieces of approx. 2cm before you process them.
3 Assemble the appliance properly before you put the plug in the wall socket.

Hand blender
The hand blender is intended for:
- blending uids, e.g. dairy products, sauces, fruit juices, soups, mixed drinks and shakes.
- mixing soft ingredients, e.g. pancake batter or mayonnaise.
- pureeing cooked ingredients, e.g. for making baby food.
1 Put the ingredients in the beaker.
See the table for the recommended quantities and processing times.
ENGLISH 7

Blending quantities and processing times
Ingredients Blending quantity Time Speed
Fruits & vegetables 100-200g 30sec. Turbo
Baby food, soups & sauces 100-400ml 60sec. 15-20
Batters 100-500ml 60sec. 15-20
Shakes & mixed drinks 100-1000ml 60sec. 15-20
2 Attach the blender bar to the motor unit (‘click’) (Fig. 2).
3 Put the plug in the wall socket.
4 Immerse the blade guard completely in the ingredients.
5 Press the on/off button or the turbo button to switch on the appliance (Fig. 3).
- When you use the on/off button, you can adjust the speed with the speed ring. The higher the
speed, the shorter the processing time required.
- The speed ring has settings from 1 (low speed) to 20 (high speed).
- When you use the turbo speed button, the appliance operates at maximum speed. In this case,
you cannot adjust the speed with the speed ring.
6 Move the appliance slowly up and down and in circles to blend the ingredients.
Medium chopper (HR1652 only)
The chopper is intended for chopping ingredients such as nuts, meat, onions, hard cheese, boiled
eggs, garlic, herbs, dry bread etc.The medium chopper is supplied with a blade unit with straight
blades and an ice-crushing blade unit with serrated blades. For all ingredients mentioned in the table
below you have to use the blade unit with straight blades. Use the ice-crushing blade unit with
serrated blades for crushing ice cubes only.
Be very careful when you handle the blade units, the blades are very sharp. Be particularly careful
when you remove the blade unit from the chopper bowl, when you empty the chopper bowl and
during cleaning.
Caution: Do not process more than 1 batch without interruption. Let the appliance cool down
for 5 minutes before you continue processing.
Note: Cut large ingredients into pieces of approx. 2cm before you process them.
1 Put the blade unit in the chopper bowl (Fig. 4).
2 Put the ingredients in the chopper bowl.
See the table for the recommended quantities and processing times.
Medium chopper quantities and processing times (HR1652 only)
Ingredients Chopping quantity Time Speed
Onions and eggs 200g 5 x 1sec. 1-5
Meat 200g 10sec. turbo
Herbs 30g 10 x 1sec. 10-15
ENGLISH8

Ingredients Chopping quantity Time Speed
Nuts and almonds 200g 30sec. turbo
Dry bread 80g 30sec. turbo
Parmesan cheese 200g 20sec. turbo
Dark chocolate 100g 20sec. turbo
3 Put the chopper lid on the chopper bowl (Fig. 5).
4 Fasten the motor unit onto the chopper lid (‘click’) (Fig. 6).
5 Put the plug in the wall socket.
6 Press the on/off button or the turbo speed button to switch on the appliance.
Note: If the ingredients stick to the wall of the chopper bowl, unplug the appliance and loosen dry
ingredients from the wall with a spatula or by adding some liquid (e.g. if you make pesto).
Whisk (HR1651 only)
The whisk is intended for whipping cream, whisking egg whites, desserts etc.
Caution: Do not process more than 1 batch without interruption. Let the appliance cool down
for 5 minutes before you continue processing.
1 Connect the whisk to the coupling unit (‘click’) (Fig. 7).
2 Put the ingredients in a bowl.
See the table for the recommended quantities and processing times.
Whisking quantities and processing times
Ingredients Whisking quantity Time
Cream 250ml 70-90sec.
Egg whites 4 eggs 120sec.
Tip: If you want to process a small quantity, tilt the beaker slightly for a quicker result (Fig. 8).
Tip:When you whip cream, use the beaker to avoid splashing.
Tip:When you beat egg whites, use a large bowl for the best result.
Tip:To prevent splashing, start at a low speed setting and continue with a higher speed after approx. 1
minute.
Note: Do not use the whisk to prepare dough or cake mixture.
3 Connect the coupling unit to the motor unit (‘click’) (Fig. 9).
4 Put the plug in the wall socket and press the on/off button.
5 After approx. 1 minute, you can press the turbo button to continue at turbo speed.
ENGLISH 9

Detaching the whisk
1 To detach the whisk, press the release button (Fig. 10).
2 To detach the coupling unit, pull it from the whisk (Fig. 11).
Milk foamer (HP1651 only)
1 Connect the milk foamer to the coupling unit (“click”). (Fig. 12)
2 Connect the coupling unit to the motor unit (Fig. 13).
3 Plug in the appliance.
4 Heat up the milk to a temperature between 55°C - 65°C/131°F - 149°F.
Tip:You will achieve the best results if you use long-life milk with 3.5% fat content.
Note: Do not heat up the milk to a temperature beyond 65°C/149°F. Never let the milk boil.
Do not process more than 1 batch without interruption. Let the appliance cool down for 5
minutes before you continue processing.
5 Pour the milk into a tall heat-resistant beaker.
6 Set the speed ring to the highest setting, press the ON/OFF button and froth the milk for
approximately 60 seconds.
Note: Clean the milk foamer immediately after use (see chapter ‘Cleaning’ and the cleaning table).
Detaching the milk foamer
1 To detach the coupling unit, press the release button (Fig. 14).
2 To detach the milk foamer, pull it off the coupling unit (Fig. 15).
3 To detach the milk foamer cones, pull them off the milk foamer (Fig. 16).
Cleaning (Fig. 17)
Do not immerse the motor unit, the coupling units or the medium chopper lid (HR1652 only) in
water, nor rinse it under the tap. Use a moist cloth to clean them (Fig. 18).
1 Unplug the appliance.
2 Press the release button on the motor unit to remove the accessory you have used.
3 Disassemble the accessory.
Tip:You can also remove the rubber ring from the chopper bowl for extra thorough cleaning.
4 See the cleaning table for further instructions.
Tip: For quick cleaning of the blender bar, pour warm water with some washing-up liquid into the beaker,
insert the blender bar and let the appliance operate for approx. 10 seconds.
Ordering accessories
If you need to replace an accessory or want to purchase an additional accessory, go to your Philips
dealer or visit www.philips.com/support. If you have problems obtaining accessories, please contact
the Philips Consumer Care Centre in your country.
ENGLISH10