Philips LX25 Series User manual

LX25, LX50, LX95 SERIES
Manufactured by:
Vision Solaire inc.
www.vision-solaire.com
[email protected]
T. 1-819-729-0450
Révision: 2.4
IMPORTANT NOTES:
• Alwaysinstallthelightingxtureonthepolebeforeinstallingthebattery.
• Thelightingxtureshouldneverbehandledwithbatteryinstalledinside.
• Thebatterycompartmentcontainsa“quickconnector”toconnectthebattery,identiedas“BATTERY”.
• Thebatterycompartmentalsocontainstwoadditionalwiresmarked“EXTERNAL SOLAR PANEL *OP-
TIONAL* “.Thesetwowiresmustneverbeconnectedtothebattery,theyareusedwhenanadditional
externalsolarpanelisinstalled.
INSTALLATION
1. Installthelightingxtureonapolewithanouterdiameterof:
• 101mm(4in)fortheLX25andLX50(roundorsquaresleeveisavailableforLX25,LX50);
• 127mm(5in)LX95(squaresleeveonlyontheLX95);
2. Slidethelightingxtureontopofthepole;
3. Usethe1/4”-20bolttosecuretheluminairetothepole,choosethedrillingpatternaccordingtoyourmodel
(LX25-50orLX95);
4. Oncethelightisinplace,openthebatteryboxdoorandinsertthebattery.Thebatteryisstandingupforthe
LX95.ThebatteryislyingonitssidefortheLX25andLX50asshownintheguresbelow;
5. Makeaquickconnectionwiththequickconnectcable;
6. Agreenindicatorlightindicatesthattheluminaireisfunctionnal.
7. Closethebatteryboxdoor,theinstallationisnowcomplete.
LEARNING DELAY
Thelightrequiresa24-hourdelaytooperateproperlyaccordingtoit’sprogram.
STEP 1, 2, 3
STEP 4 STEP 5
Indicatorlights

LX25, LX50, LX95 SERIES
Manufactured by:
Vision Solaire inc.
www.vision-solaire.com
[email protected]
T. 1-819-729-0450
Révision: 2.4
SolarModule
Orientation Period Autonomy losses
South
(≈optimal)
Annual 0%
Summer 0%
Winter 0%
East/West
Annual -17%
Summer -9.8%
Winter -28%
North
Annual -35.8%
Summer -21.6%
Winter -54.8%
ORIENTATION AND AUTONOMY 1.1INSTALLATIONGUIDELINES
Toavoidalossofautonomyandamalfunction:
• Theluminairemustbeinstalledhorizontallyandmustneverbetilted;
• Theluminairemustbeinstalledattheendofthepost;
• Theluminairemustbeinstalledinanopenspacewithnotreesorstructures
nearby,thiscouldfavoursnowaccumulationandshading;
• Thesolarmodulemustbeideallyorientedtowardsthesouth,otherwisesee
table“ORIENTATIONANDAUTONOMY”.
Failingtofollowtheserecommendationscanresultinlossofsystemperformance.
FACTORSAFFECTINGAUTONOMY:
Lackofsunshine,verylowambienttemperature,snowaccumulationduetotrees
or structures nearby, shading due to nearby trees or structures, solar module
orientation(seetable),toomanyunplannedoccupancydetections(road,unusual
activitiesandevents),sunshinebelowthemonthlyaverages,timedelaytoohigh
ontheoccupancysensor.

LX25, LX50, LX95 SERIES
Manufactured by:
Vision Solaire inc.
www.vision-solaire.com
[email protected]
T. 1-819-729-0450
Révision: 2.4
1.2STORAGEANDHANDLING:
Ifyouwishtostoretheluminaire,thebatteryneedstoberechargedbeforestor-
ingforaperiodof15daysormoreinordertopreventdamagetothebattery.The
luminairemustbestoredat20°Croomtemperature.
Theluminaireshouldneverbemanipulatedwhenthebatteryisinside.Use
thequickaccessdoortoremovethebatterybeforehandling.
1.3DEEPDISCHARGEPROTECTION
Thisprotectionsignicantlyincreasesbatterylifespan.Thisprotectionalsopre-
ventspermanentdamagetothebatterycausedbyverydeepdischargesduring
coldweather.Whenthebatteryreachesa50%stateofcharge,thebatteryis
automaticallydisconnectedfromthesystemuntilit’sstateofchargereach-
es85%i.e.about1dayofsunshineinsummerandabout4daysofsunshinein
winter.
1.4PIRSENSORTIMEDELAYFEATUREADJUSTMENT
Pleasebecareful,thetimedelaytrimpotisafragilecomponent.
TheTimeDelay(30secondsto30minutes)adjustmenttrimpotislocatedunder
thelensassembly.Thetrimpotisaccessedeasily.Gentlyunscrewthelensas-
sembly.Donotremovethethumbscrewcollar;itholdsthesensorinplaceonthe
xture. Setthetimedelaytothedesiredsetting.Thetimedelaycanbesetfrom
30seconds(fullycounterclockwise) to30minutes(fully clockwise).Werecom-
mendnottogoover5minutes.Thetimedelaystartswhennomorepresenceis
detected.
1.5DAY-NIGHTTRANSITION
Thextureusesthesolarpaneltodetectdayandnightperiods.Thenighttransi-
tionrequiresaverylowbrightnesslevelfor5continuousminutes.Thisconstraint
preventsfalsenighttransitions.Avoidexposingtheluminairetoanarticiallight
sourcethatmaycausesynchronizationerrorsbysimulatingtheday.Ifthexture
operates erratically, make sure the solar module is not covered with debris or
heavysnow.Theluminaireautomaticallycorrectssynchronizationerrorsafter24
hours.Theoccupancysensorhasitsownphotocell,whichdoesnotactivatewhen
theambientbrightnessistoohigh.

B
2.00
3.00
TYP.
.35
1.00
DETAIL
B
SCALE
1 : 3
NOTE: The installation of the lamp on the top of the post requires drilling the post as per the presented drilling patturn. The lamp will be secured using one bolt through the lamp post. The holes should be pointing in the direction of the desired orientation.
DIRECTION OF LIGHTING
REV.
DESCRIPTION
DATE
PAR
1
UPDATE OF THE NOTE
26 MAR 2020
JFOL
A A
B B
2 2
1 1
4 IN POST DRILLING
PATTERN
LX25 / LX50
1
DO NOT SCALE DRAWING
LX25-02-EN
SHEET 1 OF 1
24 MAY 19
24 MAY 19
JFOL
JFOL
UNLESS OTHERWISE SPECIFIED:
SCALE: 1:5
WEIGHT:
REV
DWG NO.
A
TITTLE
NAME
DATE
PROPRIETARY AND CONFIDENTIAL
Q.A.
MFG APPR.
ENG APPR.
CHECKED
DRAWN
FINISH
MATERIAL
INTERPRET GEOMETRIC TOLERANCING PER:
DIMENSIONS ARE IN INCHES TOLERANCES: ANGULAR:
1
TWO PLACE DECIMAL
0.6"
THREE PLACE DECIMAL
0.31"
HOLES:
0.05"
THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF SOLAR VISION. ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION OF SOLAR VISION IS PROHIBITED.
COMMENT
SIZE

B
2.500
1.250 5.125
TYP.
.35
DETAIL
B
SCALE
1 : 3
NOTE: The installation of the lamp on the top of the post requires drilling the post as per the presented drilling patturn. The lamp will be secured using one bolt through the lamp post. The holes should be pointing in the direction of the desired orientation.
DIRECTION OF LIGHTING
REV.
DESCRIPTION
DATE
PAR
1
UPDATE OF THE NOTE
26 MAR 2020
JFOL
A A
B B
2 2
1 1
5 IN POST DRILLING
PATTERN
LX95
1
DO NOT SCALE DRAWING
LX95-02-EN
SHEET 1 OF 1
30 MAY 19
30 MAY 19
JFOL
JFOL
UNLESS OTHERWISE SPECIFIED:
SCALE: 1:5
WEIGHT:
REV
DWG NO.
A
TITTLE
NAME
DATE
PROPRIETARY AND CONFIDENTIAL
Q.A.
MFG APPR.
ENG APPR.
CHECKED
DRAWN
FINISH
MATERIAL
INTERPRET GEOMETRIC TOLERANCING PER:
DIMENSIONS ARE IN INCHES TOLERANCES: ANGULAR:
1
TWO PLACE DECIMAL
0.6"
THREE PLACE DECIMAL
0.31"
HOLES:
0.05"
THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF SOLAR VISION. ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION OF SOLAR VISION IS PROHIBITED.
COMMENT
SIZE