Introduction
Philips TRESemmé straighteners provide ultra-fast and super-smooth
straightening results. The EHD+ (Even Heat Distribution) Ceramic Nano-
Silver Technology provides optimal heat distribution at high temperatures
for long-lasting, professional results.
Important
Read this user manual carefully before you use the appliance and save it for
future reference.
Danger
Keep the appliance away from water. Do not use it near or over water
contained in baths, washbasins, sinks etc. When you use the appliance in
a bathroom, unplug it after use. The proximity of water presents a risk,
even when the appliance is switched off.
Warning
Check if the voltage indicated on the appliance corresponds to the local
mains voltage before you connect the appliance.
Check the condition of the mains cord regularly. Do not use the
appliance if the plug, the mains cord or the appliance itself is damaged.
If the mains cord is damaged, you must have it replaced by Philips, a
service centre authorised by Philips or similarly qualied persons in
order to avoid a hazard.
This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safety.
Children should be supervised to ensure that they do not play with the
appliance.
Keep the appliance away from non-heat-resistant surfaces and never
cover the appliance with anything (e.g. a towel or clothing) when it is
hot.
Keep the appliance away from ammable items.
Caution
For additional protection, we advise you to install a residual current
device (RCD) in the electrical circuit that supplies the bathroom. This
RCD must have a rated residual operating current not higher than
30mA. Ask your installer for advice.
The straightening plates and the plastic parts near the plates reach a
high temperature quickly. Prevent the hot surfaces of the appliance from
coming into contact with your skin.
Only use the appliance on dry or damp hair.
Do not leave the plates in your hair for more than a few seconds at a
time as this may cause damage to your hair.
Always unplug the appliance after use.
Do not wind the mains cord round the appliance.
Wait until the appliance has cooled down before you store it.
Keep the straightening plates clean and free of dust, dirt and styling
products such as mousse, spray and gel. Dust, dirt and styling products
may cause damage to the nano-silver ceramic-coated straightening
plates.
The plates have a nano-silver ceramic coating. This coating slowly wears
away over time. This does not affect the performance of the appliance.
If you use the appliance on colour-treated hair, the straightening plates
may stain.
The maximum temperature occurs just after heating up. The actual
temperature during use may be lower.
Never leave the appliance unattended when it is plugged in.
Electromagnetic elds (EMF)
This Philips appliance complies with all standards regarding electromagnetic
elds (EMF). If handled properly and according to the instructions in this
user manual, the appliance is safe to use based on scientic evidence
available today.
Preparing for use
Washing your hair
Everybody wants shiny and beautiful hair. A good hair-washing routine can
help to achieve this.
1 Wet your hair thoroughly for 30-60 seconds.
2 Pour some TRESemmé shampoo into the palm of your hand. Spread it
between your hands and distribute it evenly through the hair.
3 Gently massage your hair and scalp. Do not rough up the hair or pull
up long hair onto the scalp, as this may cause tangles.
4 Massage your scalp with your ngertips. This stimulates blood
circulation and is gentler to the hair cuticles.
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
ENGLISH 5 Rinse your hair thoroughly, as poor rinsing can result in dull hair.
Finish with a cold rinse for extra shine.
Note:After shampooing, use TRESemmé remoisturising conditioner to detangle
the hair and improve its condition.
Drying your hair
To get super-smooth results, it is essential to prepare your hair for
straightening. Dry your hair properly with a hairdryer to ensure a
professional, smooth nish.
1 After washing, squeeze excess water out of the hair with your hands
and then towel-dry the hair. Use a comb to disentangle the hair gently
from the roots to the tips.
2 Divide the hair into sections using clips. Start at the back.
3 To dry each section, pull a straightening brush down the hair length.
Follow the brush with the hairdryer, with its nozzle pointing towards
the hair ends.
4 When you have nished drying each section, set the hairdryer to the
cool setting for a nal cool shot. This closes the cuticles and adds
shine to the hair.
Using the appliance
Straightening your hair
Straighteners are powerful styling tools and must always be used with care.
As with all straighteners that reach salon-high temperatures, do not use the
appliance frequently to avoid damage to the hair.
If you use the straightener incorrectly or if you use it at the wrong
temperature setting, you could overheat your hair or even burn it.
Always follow the following steps:
1 Put the plug in the wall socket.
2 Turn the on/off switch.
The power-on light goes on.
3 Let the appliance heat up.
Never leave the appliance unattended when it is plugged in.Always put
the appliance on a heat-resistant surface when it heats up and when it is
hot.
4 Turn the adjustment knob to the preferred temperature setting
(1 to 25) (Fig. 1).
5 Comb or brush your hair so that it is disentangled and smooth
(Fig. 2).
Use a comb to divide the hair into sections. Do not put too much hair in
one section.
Note:Tip: it is better to section off the crown area and to straighten the hair
underneath rst. Then straighten the top area.
6 Take a section that is not wider than 5cm. Place it between the
straightening plates and press the handles of the appliance rmly
together.
7 Slide the straightener down the length of the hair in 5 seconds, from
root to hair end, without stopping to prevent overheating (Fig. 3).
8 Repeat this process after 20 seconds until you have achieved the
desired look.
9 Let your hair cool down. Do not comb or brush it before it has
cooled down, as this would ruin the hairstyle you have just created.
Cleaning
1 Make sure the appliance is switched off and unplugged.
2 Let the appliance cool down completely on a heat-resistant surface.
3 Clean the appliance with a damp cloth.
Storage
Never wind the mains cord round the appliance.
1 Make sure the appliance is switched off and unplugged.
2 Let the appliance cool down on a heat-resistant surface before you
store it.
3 Use the easy-lock system to lock the straightening plates together
before you store the appliance.
,
1 2 3 4
