Physio Control LIFEPAK CR PLus Guide

How do I replace the QUIK-PAK™ electrode packet on my LIFEPAK CR Plus or
LIFEPAK EXPRESS debrillator?
Explanation:
Both the QUIK-PAK electrode packet and the CHARGE-PAK™ battery charger should be replaced at the same time after each use of the
defibrillator or when the readiness display shows the symbol.
Steps to resolve:
1. Press the ON/OFF button to open the defibrillator lid (voice
instructions will sound).
2. Press and hold down the ON/OFF button for 2 seconds to turn
o the defibrillator voice prompts and save battery power.
3. To remove the old electrode packet, unplug the electrode
connector from the receptacle.
4. Slide the anchor pin from the slot.
5. Discard the outdated or used electrode packet according to lo-
cal regulations or in the trash.
LIFEPAK CR®Plus / LIFEPAK EXPRESS®DEFIBRILLATORS

For further information, please contact your Physio-Control representative at 800.442.1142 or visit our website at www.physio-control.com
©August 2009 Physio-Control, Inc. Redmond, WA, 98052, USA. All rights reserved. All names herein are trademarks or registered trademarks of their respective owners.
6. To install the new electrode, slide the anchor pin into the slot.
7. Plug the electrode connector into the receptacle.
8. Ensure the new electrode packet is centered on the defibrillator
and tucked behind the lip before closing the lid.
9. Close the lid. Confirm that the packet “Use By” date is visible
through the window in the upper right-hand corner of the lid.
Reference:
LIFEPAK CR Plus and LIFEPAK EXPRESS Defibrillator Operating Instructions, Section 5.3
Applies to:
LIFEPAK CR Plus Defibrillator
LIFEPAK EXPRESS Defibrillator