Precor CW-119 User manual

CW-119
Assembly Guide

CW-119 Assembly Guide
page 3
IMPORTANT SAFETY INSTRUCTIONS
Important Safety Instructions
Important Safety Instructions
When using exercise equipment, basic precautions
should always be taken, including the following:
• Read all instructions before assembling the
CW-119. These instructions are written for your
safety and to protect the unit.
• Read each step in the assembly instructions and
follow the steps in sequence. Do not skip ahead. If
you skip ahead, you may learn later that you have
to disassemble components and that you may
have damaged the equipment, which would void
the Precor Limited Warranty.
• Assemble and operate the CW-119 on a solid, level
surface. Locate the unit a few feet from walls or
furniture to provide easy access.
• Do not allow children or those unfamiliar with its
operation on or near the equipment. Do not leave
children unsupervised around the unit.
• Use the equipment only for its intended purpose.
Do not use accessory attachments that are not
recommended by the manufacturer, as such
attachments may cause injuries.
• Do not attempt to service the CW-119 yourself. The
unit does not contain any user-serviceable parts.
Obtaining Service
For information about product operation or service,
refer to the Precor web site at www.precor.com where
you can also find customer support numbers or a list of
Precor authorized service centers.
If you contact Customer Support, have the serial
number available.
You can find the serial number printed on a label
affixed to the CW-119. For future reference, write the
serial number in the space provided below.
Serial number: _______________________

CW-119 Assembly Guide
page 4
Table of Contents
1
2
Important Safety Instructions .................................................................................. 3
Obtaining Service ..................................................................................................................................... 3
Preparations ............................................................................................................... 5
Unpacking the Equipment......................................................................................................................... 5
Required Tools .......................................................................................................................................... 5
Installation Requirements ......................................................................................................................... 5
Hardware Kit ............................................................................................................................................. 6
Assembly Instructions .............................................................................................. 7
Open the Box ............................................................................................................................................ 7
Assemble the Unit..................................................................................................................................... 8
Assemble the Pads ................................................................................................................................... 9
Clean the Pads and Assembly .................................................................................................................. 10
Limited Warranty Statement ...................................................................................................................... 11
Specifications ............................................................................................................................... Back cover
Table of Contents

CW-119 Assembly Guide
page 5
1Preparations
Preparations
The CW-119 parts are inspected before shipment.
Each unit contains several pieces that require
assembly. You must obtain adult assistance during the
assembly process.
Unpacking the Equipment
When you open the box, carefully unpack the pieces
and lay them on the floor near the location where you
plan to use them.
CAUTION: Be careful when you remove the
packaging material with a utility knife. Do not cut
the upholstery or scratch the paint.
If any items are missing, contact the dealer from whom
you purchased the unit. For more information, refer to
Obtaining Service.
Required Tools
Tools that you need to obtain before assembling the
unit include:
❏Wire cutter or utility knife
❏SAE hex key set
Installation Requirements
Follow these installation requirements when
assembling the unit:
•Review the Important Safety Instructions.
•Assemble the unit where it will be used.
Provide ample space around the unit.
•Install components in the sequence shown.
•Insert all fasteners in the same direction.
For aesthetic purposes, insert all the fasteners
in the same direction unless instructed (in text or
illustrations) to do otherwise.
•Leave room for adjustments. Tighten the
fasteners to keep the unit stable, but leave room for
adjustments. Do not fully tighten fasteners until
instructed to do so.

CW-119 Assembly Guide
page 6
⁵⁄₁₆-inch x 1¼-inch buttonhead screw (C) 7
⁵⁄₁₆-inch washer (E) 7
Fastener Qty
Hardware Kit
Preparations, continued
³⁄₈-inch x ¾-inch buttonhead screw (A) 4
³⁄₈-inch split washer (B) 4
⁵⁄₁₆-inch split washer (D) 7

CW-119 Assembly Guide
page 7
2Assembly
Instructions
Assembly Instructions
Assembly of the CW-119 takes about 45 minutes to
complete. If this is the first time you have assembled
this type of equipment, plan on allowing more time.
Be careful to open boxes and assemble components
in the sequence presented in this manual.
Note: With so many assembled parts, proper alignment
and adjustment is critical. While tightening the fasteners,
be sure to leave room for adjustments. Do not fully
tighten fasteners until instructed to do so.
Open the Box
Use wire cutters to open the box and remove the
packing materials.
The illustration shows how the CW-119 will look when
you have completed its assembly. The callouts identify
specific pieces.
Seat Pad
Stabilizer
Main Frame
Back Pad

CW-119 Assembly Guide
page 8
Assemble the Unit
Attach the Main Frame to the Stabilizer using
four ³⁄₈-inch X ¾-inch buttonhead screws (A)
four ³⁄₈-inch split washers (B)
Wrench tighten.
Note: Make sure the wheels on the Stabilizer are
positioned as shown in the illustration.
Assemble the Unit
4 - ¾" buttonhead screws
4 - split washers

CW-119 Assembly Guide
page 9
Assemble the Pads
Assemble the Pads
1. Attach the Seat Pad to the Seat Adjustment using
three 1¼-inch buttonhead screws (C)
three ⁵⁄₁₆-inch split washers (D)
three ⁵⁄₁₆-inch washers (E)
Wrench tighten.
2. Attach the Back Pad to the Back Adjustment using
four 1¼-inch buttonhead screws (C)
four ⁵⁄₁₆-inch split washers (D)
four ⁵⁄₁₆-inch washers (E)
Wrench tighten.
This completes the assembly of the CW-119.
3 - 1¼" buttonhead screws
3 - split washers
3 - washers
4 - 1¼" buttonhead screws
4 - split washers
4 - washers

CW-119 Assembly Guide
page 10
Clean the Pads and Assembly
Clean the Pads and Assembly
To clean the pads, moisten a clean, soft cloth in a mild
solution of soap and water and wipe all the parts
thoroughly. Dry the pad with a clean, dry cloth.
Use the same procedure to clean the Main Frame and
plastic parts.
Frequently vacuum the floor underneath the CW-119 to
prevent the accumulation of dust and dirt. If necessary,
use the Seat Pad to lift the front end and tip the
CW-119 onto its wheels to roll it to a different location.