Premier designs WindGarden 26827 User manual

Vintage RV Spinner
assembly
instructions
B
Step 1
The Strut Assembly of your Vintage RV spinner is shipped in two sections. The Front Strut Assembly comes already inserted into the RV
Body Sleeve. There is also a Stiener Rod within the Sleeve. Open the Velcro seam on the RV Body Sleeve and connect the Front Strut
Assembly to the Stiener Rod. (diagram A)
Step 2
Insert the Rear Strut Assembly into the Body Sleeve and connect to the Front Strut Assembly. (Diagram B)
Completed Internal Strut Assembly.
Make sure all parts connect as shown.
Internal Strut Assembly
will have to be connected
to Internal Stiener
WindGarden
by premier designs
www.premierkites.com
sku #26827
Body Sleeve
Body Sleeve
Front Strut Assembly
(Internal Body
Struts)
Front Strut Assembly
(Internal Body Struts)
Rear Strut Assembly
will have to be
connected to
Internal Body Struts
A
Stiener
Rod
Velcro
Seam Plastic Tip of Support Pole
Support Pole
Push Star Lock Hub rmly
onto Plastic Tip of Support Pole
NOTE: To make insertion process
easier, place bottom of Support Pole
on a hard, at surface and push
down on Star Lock Hub.
Star Lock Hub

D
C
PLEASE NOTE: Although your Vintage RV Spinner is constructed with UV resistant SunTexTM fabric, it is recommended that you take it inside
during storms and harsh weather to preserve its durability.
E
Support
Pole
Ground
Stake
ferrule
Step 3
Slide the narrow, plastic tipped end of the Support Pole into Star Lock Hub. Push
down on the hub until The Support Pole locks into place and cannot be removed.
Close Velcro Seam. (Diagram B)
Step 4
Slide the Spinner Axles onto the Wheel Strut Assemblies. Tighten knobs on the "T"
Joints to hold the Axles to the Struts. (Diagram C)
Step 5
Take one of the two Spinner Wheels and slide it onto one the Spinner Axle. Slide
second Spinner Wheel onto Spinner Axle. (Note: Spinner Wheels on same axle
should spin in opposite directions. Before putting second Axle Cap into place,
make sure wheels spin as shown in diagrams C and D.) Pound Axle Caps onto
uncapped ends of Spinner Axle using a mallet or piece of wood. (Diagram D)
Step 6
Drive Ground Stake into ground. Slide assembled Vintage RV Spinner into Ground
Stake. (Diagram E)
Vintage RV Body
Spinner
Axle "T" Joint
First, slide Spinner
Axle onto
Strut Assembly
Second, tighten
knob on "T" Joint
Wheels on
same axle
should spin
in opposite
directions
Spinner
Wheel
Axle Cap
Slide Spinner
Wheels onto Spinner
Axle, then hammer
Axle Cap onto end