Premier designs Wind Garden 25932 User manual

B & O Tender Spinner
assembly
instructions
Rear
Strut
Assembly Center
Strut
Assembly
A
B
Front
Strut
Assembly
completed
Strut
Assembly
B & O Tender Body Sleeve
sku #25932
Step 1
The Strut Assembly of your B & O Tender spinner is shipped in three sections. Connect Center Rods of the Rear Strut Assembly and the Front Strut
Assembly to the Center Rod of the Center Strut Assembly as shown. (diagram A)
Step 2
Open Velcro straps and insert completed Strut Assembly into bottom of B & O Tender Body Sleeve as shown. Reclose Velcro straps. (diagram B)
Completed Internal Strut Assembly.
Make sure all parts connect as shown.

CD
PLEASE NOTE: Although your B & O Tender Spinner is constructed with UV resistant SunTexTM fabric, it is recommended that you take it inside
during storms and harsh weather to preserve its durability.
E
Support
Pole
Ground
Stake
ferrule
Spinner Wheels
on same side of
B & O Tender
should spin in
same direction
after assembly
Step 3
Take one of the Spinner Axles and slide it onto the Rear Strut Assembly at back of B & O Tender
Body. Tighten the knob on the "T" Joint to hold the Axles to the Struts. (diagram C)
Step 4
Take one of the four Spinner Wheels and slide it onto one of the two Spinner Axles. Slide
second Spinner Wheel onto Spinner Axle. (Note: Spinner Wheels on same side of B & O
Tender should spin in same direction and Spinner Wheels on same axle should spin in
opposite directions. Before putting second Axle Cap into place, make sure wheels spin
as shown in diagrams D and E.) Pound second Axle Cap onto uncapped end of Spinner Axle
using a mallet or piece of wood. (diagram D)
Step 5
Repeat Step 4 using second Spinner Axle and the two remaining Spinner Wheels to assemble
the front Spinner.
Step 6
Pound Ground Stake into ground and insert non-ferruled end of Support Pole into Ground
Stake. Insert Upper Pole Section of completed B & O Tender Spinner into ferrule on top of
Support Pole. (diagram E)
Spinner
Wheel Axle
Cap
Slide Spinner
Wheels onto Spinner
Axle,then hammer
Axle Cap onto end
Wheels on
same axle
should spin
in opposite
directions
B & O Tender Body
Spinner
Axle
"T" Joint
First,slide Spinner
Axle onto
Strut Assembly
Second,tighten
knob on "T" Joint