Premier designs Wind Garden ME109 Airplane Spinner User manual

Step 1
Insert the two Wing Struts through the two
openings at the wing tip of one of the
wings. Guide them through the inside of
the wings.
(diagrams A & B)
Step 2
Pass the struts through the Channel Holes
in the fuselage, found underneath the
wings and through the Aluminum Channel
inside the fuselage. Guide the struts
through the inside of the wing to the other
wing to the end of the wing tip. This wing
tip should be sewn closed, so the struts can
not pass through. You may have to shift the
Fuselage Channels Holes slightly to guide
them through. (diagram C)
Wing Strut
Bottom of Wing
Wing Strut
WindGarden
by premier designs
ME109 Airplane Spinner
assembly
instructions
Plane Fuselage x 1 Spinner Propeller x 1
Stabilizer Cross Strut x 1
Ground Stake x 1
Support Pole x 1
Wing Struts x 2
A
Wing Strut
Wing Opening
for struts
Wing
B
C
Bottom of Wing
Channel Holes
Main Fuselage
Hub
Fuselage
Aluminum
Channel
Wing Strut

D
Step 4
Remove the red, wooden end cap and spacer from
the propeller axle exiting from the front end of the
fuselage. Slide on the Spinner Propeller. Place the
Spinner Propeller onto the propeller axle, then
replace the spacer and the end cap. (diagram F)
Step 5
Pound Ground Stake into ground and insert
non-ferruled end of Support Pole into Ground
Stake. Insert Upper Pole Section of completed
P-40 Warhawk Spinner into ferrule on top of
Support Pole. (diagram G)
Stabilizer
Strut
Internal Fuselage
Strut
Fuselage
Stabilizer
Hole
E
Step 3
Insert the Stabilizer Strut into the Stabilizer
Sleeves located underneath the stabilizer. Guide
the Stabilizer Strut through the Fuselage
Stabilizer Hole and to the other side. Then slide
the Stabilizer Strut through the other sleeve on
the other side of the stabilizer. (diagram E)
You may have to shift the Fuselage Stabilizer
Hole slightly to line up the stabilizer strut
through the hole. Shifting the Fuselage Stabilizer
Hole can be accomplished by grabbing the main
fuselage hub and moving the internal fuselage
strut.
PLEASE NOTE: Although your Airplane Spinner is
constructed with UV resistant SunTex
TM
fabric, it is
recommended that you take it inside during storms
and harsh weather to preserve its durability.
G
Support Pole
Ground Stake
Stabilizer
Sleeve
Hidden
Opening
F
Main
Fuselage
Hub