Premier designs Wind Garden 25948 User manual

Sport Pick-Up Truck
assembly
instructions
Rear
Strut
Assembly
Center
Strut
Assembly
A
B
Step 1
The Strut Assembly of your Sport Pick-Up Truck spinner is shipped in three sections. Connect Center Rods of the Rear Strut Assembly and the Front Strut
Assembly to the Center Rod of the Center Strut Assembly as shown. (diagram A)
Step 2
Open Velcro straps and insert completed Strut Assembly into bottom of Sport Pick-Up Truck Body Sleeve as shown. Reclose Velcro straps. (diagram B)
Front
Strut
Assembly
completed
Strut
Assembly
Sport Pick-Up Truck
Body Sleeve
Completed Internal Strut Assembly.
Make sure all parts connect as shown.
WindGarden
by premier designs
www.premierkites.com
sku #25948

CD
PLEASE NOTE: Although your Sport Pick-Up Truck Spinner is constructed with UV resistant SolarMaxTM fabric, it is recommended that you take it
inside during storms and harsh weather to preserve its durability.
E
Support
Pole
Ground
Stake
ferrule
Spinner Wheels
on same side of
Sport Pick-Up Truck
should spin in
same direction
after assembly
Step 3
Take one of the Spinner Axles and slide it onto the Rear Strut Assembly at back of Sport
Pick-Up Truck Body. Tighten the knob on the "T" Joint to hold the Axles to the Struts. (diagram
C)
Step 4
Take one of the four Spinner Wheels and slide it onto one of the two Spinner Axles. Slide
second Spinner Wheel onto Spinner Axle. (Note: Spinner Wheels on same side of Sport
Pick-Up Truck should spin in same direction and Spinner Wheels on same axle should
spin in opposite directions. Before putting second Axle Cap into place, make sure wheels
spin as shown in diagrams D and E.) Pound second Axle Cap onto uncapped end of Spinner
Axle using a mallet or piece of wood. (diagram D)
Step 5
Repeat Step 4 using second Spinner Axle and the two remaining Spinner Wheels to assemble
the front Spinner.
Step 6
Pound Ground Stake into ground and insert non-ferruled end of Support Pole into Ground
Stake. Insert Upper Pole Section of completed Sport Pick-Up Truck Spinner into ferrule on top
of Support Pole. (diagram E)
Spinner
Wheel
Axle
Cap
Slide Spinner
Wheels onto Spinner
Axle,then hammer
Axle Cap onto end
Wheels on
same axle
should spin
in opposite
directions
Sport Pick-Up Truck Body
Spinner
Axle
"T" Joint
First,slide Spinner
Axle onto
Strut Assembly
Second,tighten
knob on "T" Joint