Premier designs Wind Garden 25684 User manual

Empty Red Golf Cart Spinner
sku #25684
assembly
instructions
Step 1
Remove Your Empty Red Golf Cart Spinner from
the package. Open the Velcro Seam along the
bottom of the Golf Cart.
Step 2
Slide Rod 1 and 2 through the opened Velcro
Seam into the corresponding Sleeve 1 and 2
as shown in Diagram A. Push Rod 1 so that
securely ts into the Hub 1 at the top left of the
frame structure as shown in Diagram A.
Step 3
Identify and align Main Strut A, Star Lock Hub,
and Main Strut B according to Diagram B. Insert
the Main Strut A rod into the Star Lock Hub
horizontal tting securely. Insert the Main Strut
B rod into the Star Lock Hub horizontal tting
securely.
Step 4
Slide the narrow plastic tipped end of the Upper
Support Pole into the Star Lock Hub. Push down
on the hub until The Support Pole locks into
place and cannot be removed.
Step 5
Position the Strut Assembly in between the
pieces of fabric and insert Rod 1 into the Hub of
Main Strut A as shown in Diagram C.
Step 6
Insert Rod 3 in between the pieces of fabric
so that it is positioned at an angle from the
bottom corner below the black bumper to just
above the Main Strut A Hub. Close Velcro Seam.
Completed internal Strut Assembly should
match Diagram C.
A
C
B
Rod 1
Rod 2
Sleeve 1
Sleeve 2
Velcro Seam
Velcro Seam
Hub 1
Star Lock Hub
Plastic Tip
of Upper
Support Pole
Push Star Lock Hub rmly onto
Plastic Tip of Support Pole
NOTE: To make insertion
process easier, place bottom
of Support Pole on a hard,
at surface and push down
on Star Lock Hub
Upper Support Pole
Main
Strut A
Main Strut A
Hub
Rod 3
Strut Assembly
Main
Strut B

Step 7
Slide the Spinner Axles onto the Wheel Strut
Assemblies. Tighten Knobs on the “T” Joints
to hold the axles to the Struts. (Diagram D)
Step 8
Take one of the four Spinner Wheels and
slide it on to one of the two Spinner Axles.
Slide second Spinner Wheel onto Spinner
Axle. (Note: Spinner Wheels on same side of
the Golf cart should spin in same direction
and Spinner Wheels on same axle should
spin in opposite directions. Before putting
second Axle Cap into place make sure
wheels spin as shown in diagrams E and F.)
Pound second Axle Cap onto uncapped end
of Spinner Axle using a mallet or piece of
wood. (Diagram E)
Step 9
Drive Ground Stake into ground and insert
the non-ferruled end of the Lower Support
Pole into the Ground Stake. Insert Upper
Pole of assembled Spinner into the ferrule.
(Diagram F)
PLEASE NOTE: It is
recommended that you
take your Golf Cart
Spinner inside during
storms and harsh weather
to preserve its durability.
D E
F
First, slide Spinner
Axle onto Strut
Assembly
Upper Support Pole
Lower Support Pole
Ground Stake
Ferrule
Second, tighten
knob on “T” Joint
Spinner Axle
Spinner
Wheel
Slide Spinner
Wheels onto
Spinner Axle
Wheels on same
axle should
spin in opposite
directions
Then hammer
Axle Cap
onto end
“T” Joint