Premier designs Wing Garden Lighthouse User manual

Lighthouse
assembly
instructions
A
Step 1
The Strut Assembly of your Lighthouse spinner is shipped in two sections. Connect
support pole (with ferrule end up) to internal strut assembly through small opening
in the bottom of the Lighthouse body as shown. (diagram A)
Lighthouse body
Internal Strut Assembly
Support Pole
Ferrule
Small opening
Completed Internal Strut Assembly.
Make sure all parts connect as shown.
sku #22362

B
Spinner
Axle
"T" Joint
First, put Spinner
Axle through
opening and align
“T” Joint with
Strut Assembly
C
Spinner
Axle
Second, slide Spinner
axle onto strut
assembly
Third, tighten
knob on “T” Joint
"T" Joint
PLEASE NOTE: Although your Lighthouse Spinner is constructed with UV resistant SunTexTM fabric, it is recommended that you take it inside during
storms and harsh weather to preserve its durability.
E
Support
Pole
Ground
Stake
Step 2
Take the Spinner Axles and insert it through the opening so that the vertical portion of “T”
Joint aligns with the vertical strut of the Internal Strut Assembly at the top of the Lighthouse
body. (diagram B) Slide the vertical portion of “T” Joint onto the vertical strut of the Internal
Strut Assembly. Tighten the knob on the "T" Joint to hold the Axle to the Strut. (diagram C)
Step 3
Take one of the two Spinner Wheels and slide it onto one of the Spinner Axles. Slide second
Spinner Wheel onto Spinner Axle. (Note: Spinner Wheels on same axle should spin in
opposite directions. Before putting Axle Caps into place, make sure wheels spin as
shown in diagram D.) Pound Axle Cap onto uncapped end of Spinner Axle using a mallet or
piece of wood. (diagram D)
Step 4
Pound Ground Stake into ground and insert non-ferruled end of Support Pole into Ground
Stake. (diagram E)
Spinner
Wheel
Axle
Cap
Slide Spinner
Wheels onto Spinner
Axle, then hammer
Axle Cap onto end
Wheels on same axle
should spin in opposite
directions
D