Premier designs WindGarden 26828 User manual

Red Wagon Spinner
assembly
instructions
A
B
Step 1
The Strut Assembly of your Red Wagon spinner is shipped in three sections. Open Velcro Tabs on the Red Wagon Body Sleeve and insert the Front Strut
Assembly and the Rear Strut Assembly into the Sleeve. Both the Front Frame and the Rear Frame should be inserted so that the Wheel Fitting is closer to
the edge of the wagon than the center. Please note that the Front Frame and the Rear Frame are identical and can be used interchangeably. Insert the
Center Hub into the Sleeve. (diagram A)
Step 2
Once the Front Strut Assembly, the Rear Strut Assembly, and the Center Hub are in place within the Body Sleeve, connect the Rear Strut Assembly to the
Center Hub. Then Connect the Front Strut Assembly to the Center Hub. (diagram B)
WindGarden
by premier designs
www.premierkites.com
sku #26828
Completed Internal Strut Assembly.
Make sure all parts connect as shown.
Center
Hub
Body Sleeve
Front
Strut
Assembly
Rear
Strut
Assembly
Velcro
Wheel
Fitting
Wheel
Fitting
Rear Strut Assembly
will have to be
connected to
Center Strut Assemby Front Strut Assembly
will have to be
connected to
Center Strut Assemby
Open
Body Sleeve

C
D
PLEASE NOTE: Although your Red Wagon Spinner is constructed with UV resistant SunTexTM fabric, it is recommended that you take it inside
during storms and harsh weather to preserve its durability.
E
Support
Pole
Ground
Stake
ferrule Spinner Wheels
on same side of
Red Wagon
should spin in
same direction
after assembly
Step 3
Take one of the Spinner Axles and slide it onto the Rear Strut Assembly at back of Red Wagon
Body. Tighten knob on the "T" Joint to hold the Axles to the Struts. (diagram C)
Step 4
Take one of the four Spinner Wheels and slide it onto one of the two Spinner Axles. Slide
second Spinner Wheel onto Spinner Axle. (Note: Spinner Wheels on same side of Wagon
should spin in same direction and Spinner Wheels on same axle should spin in opposite
directions. Before putting second Axle Cap into place, make sure wheels spin as shown
in diagrams D and E.) Pound second Axle Cap onto uncapped end of Spinner Axle using a
mallet or piece of wood. (diagram D)
Step 5
Repeat Steps 3 and 4 using second Spinner Axle and the two remaining Spinner Wheels to
assemble the front Spinner.
Step 6
Pound Ground Stake into ground and insert non-ferruled end of Support Pole into Ground
Stake. Insert Upper Pole Section of completed Red Wagon Spinner into ferrule on top of
Support Pole. (diagram E)
Spinner
Wheel
Wheels on
same axle
should spin
in opposite
directions
Red Wagon Body
Spinner
Axle
"T" Joint
First, slide Spinner
Axle onto
Strut Assembly
Second, tighten
knob on "T" Joint
Axle
Cap
Slide Spinner
Wheels onto Spinner
Axle, then hammer
Axle Cap onto end