Premier designs Wind Garden Gee Bee Spinner User manual

A
Step 1
Insert the two Wing Struts through the two
openings at the wing tip of one of the
wings. Guide them through the internal
sleeves sewn inside of the wings. The
longer of the two struts is inserted through
pocket closer to the leading edge of the
wing. (diagrams A & B)
Step 2
Pass the struts through the Channel Holes
in the fuselage, found underneath the
wings and through the Aluminum Channel
inside the fuselage. Guide the struts
through the internal sleeves of the other
wing to the end of the wing tip. This wing
tip should be sewn closed, so the struts can
not pass through. (diagram C)
PK1983
openings in seams of the wing tip
for inserting wing struts
Long Wing Strut
Short Wing Strut
Wing
Wing Strut
Wing Opening
for struts
B
WindGarden
by premier designs
Gee Bee Spinner
assembly
instructions
Plane Fuselage x 1 Spinner Propeller x 1
Landing Gear Wheel Axle x 1
Stabilizer Cross Strut x 1
Ground Stake x 1
Support Pole x 1
Wing Struts x 2
C
Bottom of Wing
Channel Holes
Main Fuselage
Hub
Fuselage
Aluminum
Channel
Wing Strut

D
F
Step 3
Insert the Landing Gear Wheel Axle into the two
black fittings located between the two landing
gear panels located underneath the wings.
(diagram D)
Step 4
Insert the Stabilizer Strut into the opening of the
Stabilizer Sleeve located underneath the
stabilizer. Guide the Stabilizer Strut through the
Fuselage Stabilizer Hole and to the other side.
Then slide the Stabilizer Strut through the other
sleeve on the other side of the stabilizer.
(diagram E)
You may have to shift the Fuselage Stabilizer Hole
slightly to line up the stabilizer strut through the
hole. Shifting the Fuselage Stabilizer Hole can be
accomplished by grabbing the main fuselage hub
and moving the internal fuselage strut.
Step 5
Remove the plastic end cap and spacer from the
propeller axle exiting from the front end of the
fuselage. Slide on the Spinner Propeller. Place
the Spinner Propeller onto the propeller axle,
then replace the spacer and the end cap.
(diagram F)
Step 6
Pound Ground Stake into ground and insert
non-ferruled end of Support Pole into Ground
Stake. Insert Upper Pole Section of completed
Gee Bee Spinner into ferrule on top of Support
Pole. (diagram G)
Stabilizer Strut
Internal Fuselage
Strut
Fuselage
Stabilizer
Hole
Stabilizer Sleeve
Opening
E
PLEASE NOTE: Although your Airplane Spinner is
constructed with UV resistant SunTex
TM
fabric, it is
recommended that you take it inside during storms
and harsh weather to preserve its durability.
Landing Gear
Wheel Axle
G
Support Pole
Ground Stake
Stabilizer
Sleeve