Progressive PA-TW-7-M User manual

+
x1
x1x1
ab
c
34.6"
27.5"
14.75"
4.9" - 19.9"
34.6"
16.3"
12.1"
Table cover size:
4.9" - 19.9"
33 lbs
Maximum Load Capacity
Height Range
Please do not exceed the maximum
load capacity.
WARNING
No. Desk converter Frame No.
No. Cable Management
TOOLS
Attention
Please place the product properly
according to it's size.
Remove desk converter from packaging and
place it on the table.
Hang the keyboard tray (a) on the desk converter mounts
(b) indicated below and then tighten both levers (c).
When removing the keyboard tray, release
the levers completely before removing the
keyboard tray.
PA-TW-7-M
x4
No. Adhesive Buckle
STEP 1
STEP 2
D C
A B
Keyboard Tray
37.4"
24.2"
33lbs
Max
Max:
4 lbs
Only use the sit stand desk on top of flat and stable surface,
strong enough to support the product and any equipment
placed on top of it.
Have any queries?
Our expert engineers are here to help!
Progressivedesk.com
[email protected]
1-800-828-9414

2
To set your preferred height, press the
lever on the right side, and adjust the
desk converter to the proper height.
Careful
1
Cable
Adhesive buckle helps to make the
cables clean and organized. Please
leave enough length of all cables for
height adjustments, otherwise it may
cause unexpected damage or injury.
Careful
Use the cable management to guide
and bundle the cables
Cable Buckle
Warning
Please do not put hands near the supporting bars, as
they change during adjustments and may cause injury.
Please leave enough length of cable
for height adjustment.
Attention
Please transport by using two people to
prevent injury or damage damage.
Attention
STEP 3
STEP 4
STEP 5
CAUTION
DO NOT place hands on or near support bars.
Pinch points are created during lifting and lowering
the desk converter. Failure to follow these
instructions may result in serious injury or damage.
Place devices and accessories onto
the desk converter carefully.
Please make sure all installed equipment are
centered on the table, and not hanging off of
the edge or it may cause injury or damage.
Peel and attach the adhesive
buckles to the underside of
the desk converter