Puretec PureMix X7 User manual

AS/NZS 3497
Licence No. WM 74726
Australian Certication
Services
User Guide
High Flow Inline Water Filter System
PureMix X7
For correct operation & installation it is essential to observe these instructions.JUL2018

2
Installation & Operation Manual Copyright © Puretec Pty Ltd 2018
What's inside
Introduction................................................................................................................................. 2
Operation...................................................................................................................................... 2
Cartridge Replacement ......................................................................................................... 3
Installation Requirements................................................................................................... 3
Installation Procedure ........................................................................................................... 3
Cartridge Changeout.............................................................................................................. 5
Substance Reduction.............................................................................................................. 6
Warranty .............................................................................................................................................7
Puretec Customer Service
Thank you for purchasing a Puretec PureMix X7 system. Your system is a proven performer
manufactured from only quality materials and components and will give years of ‘spring
fresh’ water, if maintained properly.
The Puretec PureMix X7 system cartridges need replacing regularly to maintain optimum
performance. This is a simple procedure when following instructions. For cartridge
replacements contact your nearest Puretec stockist.
Customer Service Helpline 1300 140 140 (Australia) 0800 130 140 (New Zealand)
Operation
The Puretec PureMix X7 system is designed to run economically for many years and this is
dependant on the initial installation and periodical maintenance.
Flush systems for 10 minutes aer any period of non-use more than 2 days.
The PureMix X7 system is designed to operate with mains, rain, harsh and rural water.
What's Inside

3
High Flow Inline Water Filter Systems
Cartridge Replacement
To maintain the high quality of the puried water the cartridges need changing every 6
months (this is dependant on water quality and usage).
You can obtain replacement cartridges from your local Puretec dealer. To maintain
performance standards and warranty, use only genuine Puretec replacements.
Order the X7-R for a replacement cartridge to suit your PureMix X7 system.
Installation
This system comes complete with an installation kit enabling it to be connected to 15mm
(½”) male thread to an existing tap or mixer tap (Cold supply only - hot water should be
ltered prior to heating). Also includes extending kit, where extra length is required.
Installation requirements
1. 15mm (½”) Cold water exi-connector to tap.
2. Water supply pressure: 200-860 kPa.
3. Water supply temperature: 0°-38°C.
Alternative ttings may be required if being connected to anything other than 15mm (½”)
copper pipe. No electrical or drainage requirements needed.
Installation Procedure
1. Select suitable location that is close to the existing tap. Remember to allow access
room for changing lter and a suitable place where water spillage will not cause
damage. Location should not be in direct sunlight.
2. Isolate water supply and release water pressure by operating faucet lever. Disconnect
existing braided hose connections.
3. Attach non-return valve to water supply with teon tape, then attach chrome adaptor
onto non-return valve with teon tape.
4. Install X7-R cartridge to the head assembly (see Fig. 1). Please note arrow on cartridge.
5. Install system assembly by positioning it in the desired location, marking the position
of xing holes and xing with mounting screws (PureMix X7 Series can be mounted
horizontally and vertically). Allow room for the connecting tubes and for removing the
cartridge (70mm).
6. Connect the braided hose onto chrome adaptor, then connect to the X7 head assembly
inlet. Ensure the hose is kink free.
Installation Guide

4
Installation & Operation Manual Copyright © Puretec Pty Ltd 2018
Installation Guide
7. Connect original braided hose attached to tap onto the head assembly outlet. Make
sure all ttings are tight and braided hose is kink free.
8. Restore the water supply and check for leaks. If they leak then undo cartridge and
check the cartridge is seated properly.
9. Run the system for at least 10 minutes (turn on mixer tap to run cold water) to remove
carbon nes. Water may appear milky, but this is normal and is only tiny air bubbles
that will clear aer a short period.
Figure 1
Head
Assembly
Also includes
Extending Kit
Existing Mixer Tap
X7-R Cartridge
HOT COLD
Braided Hose
Non-Return Valve

5
High Flow Inline Water Filter Systems
Cartridge Changeout
Cartridge Changeout
1. Place container under lter in case of drips.
2. Isolate water supply and release water pressure by operating faucet lever.
3. Unscrew X7-R cartridge in a clock-wise direction. Discard old cartridge.
4. Take o red cap from the new cartridge. Twist new cartridge into head until rmly
seated. Please note arrow on cartridge to indicate this.
5. Restore water supply.
6. Check for any leaks, rectify any before leaving the unit.
Aer installing cartridge ush unit for 5 - 10 minutes.
Use Guidelines
• Use for mains, rain, harsh and rural water supply.
• Minimum operating pressure 200 kPa.
• Maximum operating pressure 860 kPa.
• Do not allow exposure to temperatures below 0°C, protect from freezing.
• Maximum operating temperature 38°C.
• Nominal ow rate 8 Lpm.
• This system must be installed according to local plumbing codes on the cold water line
only.
• Replacement Cartridge: X7-R
• This system requires regular replacement of the lter cartridge to maintain proper
operation. Varying chlorine, sediment, or organic substance levels may aect
replacement frequency.
• Be sure to change the lter cartridge at least every 37,500 litres or 6 months which
ever occurs rst; or whenever you detect a change in taste, odour, or decrease in ow.
Caution: Do not use with water that is microbiologically unsafe or of unknown quality
without adequate disinfection before or after the system.

6
Installation & Operation Manual Copyright © Puretec Pty Ltd 2018
Performance Data
Performance Data
Substance Guidelines*
Average
Inuent
Concentration
Max Euent
Concentration
Min Percent
Removal
Average
Euent
Concentration
Average
Percent
Removal
NSF Standard 42 Drinking Water Treatment Units
Chlorine
(56,775 L)
5 - He al th
0.6 - Aesthetic 2.1 0.3 50% 0.25 >95%
Test Parameters
Hardness, Total mg/L 140
TDS mg/L 330
Temp deg C 20
Turbidity NTU ND (0.1)
pH 7.61 *Australian Drinking Water Guidelines - 1996
ND = Not Detected
This appliance meets the domestic water treatment appliance Standards AS/NZS3497 for the following
water treatment processes:
Class Treatment type Function Pass
I Microbiological Status Will stop bacteria increasing, but will not
remove them unless II(a) is passed.
N/A
Bacteriostatic
II Microbiological Treatment
II (a) Bacteria Removal Will remove or inactivate bacteria. N/A
II (b) Virus Removal Will remove or inactivate virus. N/A
II (c) Protozoa Removal Will remove or inactivate Cryptosporidium
and Giardia, but will not remove or
inactivate bacteria and virises unless II(a)
and II(b) is passed.
N/A
III Turbidity & Particulate Reduction Reduces cloudiness. YES
IV Taste & Odour Reduction Reduces taste & odours. YES
V Chemical Treatment Decreases chlorine. YES

7
High Flow Inline Water Filter Systems
Warranty
Warranty
Any claim under this warranty must be made within 10 Years of the date of purchase of the product.
This product is warranted to be free of defect of material and workmanship for 10 Years from date of
purchase. 10 year warranty is 1 year parts and labour plus 9 years parts only. Excludes cartridge.
To make a claim under the warranty, take the product and proof of purchase to place where you
purchased the product, and they will lodge a Warranty Request with Puretec.
Puretec will pay your reasonable, direct expenses of claiming under this warranty. You may submit
details and proof of your expense claim to place of purchase for consideration.
The warranty only applies if the product was used and/or installed in accordance with the user guide
and/or installation instructions. This warranty is given in lieu of all other express or implied warranties
and manufacturer shall in no circumstance be held liable for damages consequential or otherwise or
delays caused or faulty manufacturing except as excluded by law.
Applicable to all above, is that the Warranties need to be approved by Puretec to ensure product
was not incorrectly used, installed or claimed. False and incorrect claims will be pursued at Puretec’s
discretion, including chargeable inspection and labour costs incurred.
Warranty/Australia
This warranty is given by Puretec Pty Ltd, ABN 44 164 806 688, 37-43 Brodie Road, Lonsdale SA 5160,
telephone no. 1300 140 140 and email at [email protected].
This warranty is provided in addition to other rights and remedies you have under law: Our goods come
with guarantees which cannot be excluded under the Australian Consumer Law. You are entitled to
replacement or refund for a major failure and to compensation for other reasonably foreseeable loss or
damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable
quality and the failure does not amount to a major failure.
Warranty/New Zealand
This warranty is given by Puretec Ltd, Reg. No 4464398, Level 2, 40 Onehunga Mall, Auckland 1061,
telephone no. 0800 130 140 and email at [email protected].
This warranty is provided in addition to other rights and remedies you have under law: Our goods come
with guarantees which cannot be excluded under the Consumer Guarantees Act. You are entitled to
replacement or refund for a major failure and to compensation for other reasonably foreseeable loss or
damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable
quality and the failure does not amount to a major failure.
Notes
Puretec water care products are designed, manufactured and supported by Puretec Pty Ltd the name
you can trust for viable and proven water solutions. The complete range of Puretec products are
developed, rened, made to meet and exceed stringent specications for the worldwide market.
Important: Sales of products are subject to our Terms and Conditions which are available upon request.
All specications, information and photos are a guide only and are subject to change without notice.
Please ring to conrm details. Warning: For correct operation of this appliance it is essential to observe
manufacturer’s instructions.