PUTCO Molle Panel Manual

`DESCRIPTION QTY
Molle Front Plate 1
Front Brackets 3
M6 Torx-Head Bolts 6
8-32 Philip’s-Head Screws 3
5/16 Well Nuts 3
Congratulations on your purchase of a high quality PUTCO®product. Should
you need any application or technical assistance, feel free to call us at:
Monday-Friday 8:00am - 5:00pm (Central Standard Time)
Contact your PUTCO®dealer for other quality accessories.
1953XXI-FP
1-800-247-3974
PLEASE READ ALL INSTRUCTIONS BEFORE INSTALLATION
AND CHECK TO SEE THAT ALL PARTS ARE INCLUDED
CONTENT LIST
T30 TORX DRIVER
REQUIRED TOOLS
INSTRUCTION GUIDE
TOYOTA TACOMA
PHILLIPS SCREWDRIVER
FRONT PANEL

MOLLE Panels Instruction Guide
1
2
Loosely assemble a well nut and Philip’s-head screw onto each of the three front brackets. Insert
the well nuts down into each of the three drain holes located towards the front of the bed floor,
then tighten the screw until the well nut is snug in the hole, but do not overtighten.
NOTE: if desired, you may omit the middle bracket if you want to keep an open drain hole.
Unscrew and remove the three required T30 Torx-head fasteners from the upper part of the bed
front, then set the front molle plate in place, and attach to the bed re-using these three fasteners.
Front bracket locations circled in red
INSTALLATION INSTRUCTIONS
1953XXI-FP
3
4
Fasten the molle plates to their brackets using the supplied M6 bolts and a T30 Torx driver.
Once the front plate is installed in the vehicle, ensure all fasteners are tightened until snug, but
do not overtighten.
Completed Tacoma MOLLE Front Plate
Your new MOLLE Panel is now successfully
installed on your vehicle!