MOLLE Panels Instruction Guide
1
2
Unscrew and remove the front in-bed rail if equipped. Tundra and Gladiator rails are attached
with T30 Torx-head bolts. Nissan rails are attached with T40 Torx-head bolts.
Loosely assemble a jam nut onto each of the supplied rubber feet, then screw the feet into the
nutserts located on the bottom flange of the molle plate. Not all molle plates will require rubber
feet.
INSTALLATION INSTRUCTIONS
1954XXI-FP
3
4
Place the molle plate on the backside of the in-bed rail, then fasten to the bed re-using the
factory hardware.
NOTE: If you are having trouble re-installing the front rail on your Tundra, you may have to
pound out the center peg from the rail using a hammer.
NOTE: If your pickup did not come equipped with in-bed rails, you can still bolt the molle
plates to the bed rail mounting holes. We have included extra M6 bolts for this case.
If applicable, adjust the rubber feet on the molle plate down until they are snug against the floor
of the bed. Secure the rubber feet in place by tightening the jam nuts against the nutserts using
a 10mm wrench.
5Once all the plates are installed in the vehicle, ensure all fasteners are tightened until snug, but
do not overtighten.
Your new MOLLE Panel is now successfully
installed on your vehicle!
Assembled Titan MOLLE Set
