PUTCO MOLLE PANELS User manual

`DESCRIPTION QTY
Molle Front Side Plate 1
Molle Rear Side Plate 1
M6 Bolts 10
Brackets 3
Rubber Feet (8FT Bed Only) 2
Jam Nuts (8FT Bed Only) 2
Congratulations on your purchase of a high quality PUTCO®product. Should
you need any application or technical assistance, feel free to call us at:
Monday-Friday 8:00am - 5:00pm (Central Standard Time)
Contact your PUTCO®dealer for other quality accessories.
1951XXI-SP
1-800-247-3974
PLEASE READ ALL INSTRUCTIONS BEFORE INSTALLATION
AND CHECK TO SEE THAT ALL PARTS ARE INCLUDED
CONTENT LIST
REQUIRED TOOLS
INSTRUCTION GUIDE
FORD F-SERIES
10MM WRENCH T30 TORX DRIVE
SIDE PANELS

MOLLE Panels Instruction Guide
1
2
Unscrew and remove the 4 tie-down plates using a T30 Torx driver. Place the side mounting
brackets behind the tie down plates, then fasten to the bed re-using factory hardware. (NOTE: for
the 6.5ft Super Duty molle the front side plate bracket is larger than the one for the rear).
Unscrew and remove the 2 rear tie-down hooks using a T30 Torx driver. Place the rear brackets
behind the rear tie-down hooks, then fasten to the bed re-using factory hardware.
INSTALLATION INSTRUCTIONS
1951XXI-SP
3
4
For F-150 8-ft beds, prepare the front side plate by loosely threading a jam nut onto each of the
rubber feet, then loosely screw the feet into the riv-nuts on the bottom flange of the front side
plate.
Fasten the side plates to their brackets using the supplied M6 bolts and a T30 Torx driver.
Rear Bracket Side Brackets
Side Plate Assembly
5Once all the plates are installed in the vehicle, ensure all fasteners are tightened until snug, but
do not overtighten.
6For F-150 8-ft beds, screw down the rubber feet on the front side plate until they are snug against
the floor of the bed, then secure in place by fastening the jam nut against the riv-nut using a
10mm wrench.