QOLSYS IQ TEMP User manual

STEP

IQ TEMP S-LINE QUICK INSTALL GUIDE

CHOOSE

INSTALLATION

LOCATION

SPECIFICATIONS

SEE REVERSE FOR REMAINING STEPS

Features:

Low Temp and High Temp Warning

•Low Temp alarm: Temperature drops below 40F,

restores when temperatures rises above 45F

•High Temp alarm: Temperature rises above 100F,

restores when temperature drops below 95F

Sensor:

•Cover tamper

•Unique ID for each function

•Temperature check every 5 minutes

•Battery checked every hour

Batteries:

(2) -Panasonic CR2032

-Energizer CR2032

-Duracell DL2032

The IQ Temp is designed to alert you if temperatures drop below 40°F or rise above

100°F. This early warning may help you protect your valuables, pets and home from

extreme heat or cold in the event of a HVAC or thermostat failure.

Mounting Locations

Ideally suited for a wide range of applications including:

•Bathrooms

•Laundry Rooms

•Basements

*NOTE: Avoid areas that may retain heat, such as furnace rooms or near hot water pipes

This is a quick guide for experienced installers only. Refer to http://dealers.qolsys.com (login required)

Document#: IQTEMP-SQG-02-17

Revision#: 2/2/18

Issue Date: FEB 2018

Qolsys Product #: QS5535-840

STEP

Select “Freeze” as your sensor

type and customize settings as

desired

Click “Add”

REMOVE

BATTERY

TABS

APPLY

ADHESIVE

INSTALL IN

DESIRED

LOCATION

*NOTE: Sensor Type “Freeze” (Sensor Group 52) is used for both Low Temp sensors and High Temp sensors. You can

customize the Sensor Name to differentiate which one you are learning

STEP

LEARN

INTO

PANEL

Place your panel in

“autolearn" mode

STEP

Open and close the case

to “tamper” the device

LEARN

AS LOW

TEMP

(40°F)

LEARN

AS HIGH

TEMP

(100°F)

Remove both of

the batteries

Hold the tamper

button, insert the

batteries, release the

tamper button

TechSupport@Qolsys.com

Qolsys Inc. proprietary.

Reproduction without permission is not permitted.

FCC ID: 2ABBZ-RF-CHW-S

IC: 11817A-RFCHWS

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference!

that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and!

(2) this device must accept any interference, including interference that may cause undesired operation of the device.

Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS (s). Son fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne doit pas provoquer d'interférences et!