1of2
For Style QR5138
Installation Guide #IS-QR5138
1of2
Package Contents
A
D
Mirror Hanger
x2
Mirror
x1
BSelf-tapping Screw
x4
Step 1 Identify Self-tapping Screws Locations for mounting the
Mirror Hangers By Using Template
-
The template included with package is provided to assist you in placing
the mirror in the location you desire. The template is a full size drawing
of your mirror and includes hanger mounting locations that your mirror
maybe hung.
Place the template on the wall in the location you have selected for
your mirror. Once you have the template in the location you desire and
making sure it is level you may tape or pin the template to the wall. Now
you may mark the holes for the mounting hardware as indicated on
your template. You may mark the mounting hardware location by either
using a pin and pushing it through the template leaving a small hole on
the wall. Or you may use a pencil and place a mark on the wall through
a small hole you cut into the template at the correct mounting location.
Remove the template from the wall and install the Mirror Hangers.
CMetal Part
x2
Mark Self-tapping Screws Locations
On The Wall Through (4) 0.25” Dia. Holes
0.25”
0.75”
28”
22”
25.25”
2” Dia.
0.25” Dia. 11.75”11.75”
TOP
TEMPLATE
Figure 1
STEP 3 Hanging the Mirror-
A. Attach Metal Parts (C) onto axles on the sides of the Mirror (D) with
the cap end of Metal Part (C) against Mirror Hangers (A). By holding
Metal Parts (C) with Mirror (D) to hang the Mirror (D) to Mirror
Hangers (A) on the wall.
Clean glass with household glass cleaner. Retain this sheet for
future reference.
A
C
D
Axle
Cap End
Figure 3
EWall Anchor
x4
STEP 2 Installing the 2 Mirror Hangers-
A. Using a 1/8” drill bit, drill holes at each (4) locations marked on the
wall surface.
B. Insert Wall Anchors (E) into drilled holes completely.
C. Using Self-tapping Screws (B) provided with the Mirror Hangers (A)
attach the 2 Mirror Hangers (A) to Wall Anchors (E).
B
A
Figure 2
Mark
E
2019 QuoizelInc. ReleasedDate:2019-02-23
visit us on-line at www.quoizel.com
Pleasegoto forproductcleaningtips.Gotothe selection.
Flatheadscrewdriver, Phillips screwdriver,pliers,gloves,safetyglasses,markingpen,1/8”drillbitanddrill.
20-30minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtobesureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethemirror. Contact your original place of purchase.
www.quoizel.com Care+Maintenance
ToolsRequired:
EstimatedAssemblyTime:
Preparation:
Warnings and Cautions
These instructions are provided for your safety. It is very important you read them completely before installing the mirror.
