real living HG-3179 User manual

�real
I v  n Q™
MESH TASK CHAIR

I I 




Read all instructions beforestarting
Clear a flat covered space to assemble
We recommend two people for assembly
Note that hardware required is provided for every step
Pay attention to orientation
Letter of the part corresponds to a sticker on the product
Number of the hardware corresponds to its number in the package
Helpful hints provided along the way
MAINTENANCE :
CARE AND CLEANING :
GENERAL BEST PRACTICES FOR ASSEMBLY :
WARNING :
Clean periodically by wiping the product with a soft clean cloth
Do not use abrasive chemicals for cleaning
Regularly check hardware and tighten if necessary
Do not use power tools
Do not exceed maximum weight capacity of 225lbs(102kg)
Do not stand or step on this chair
Do not use this chair unless all bolts, screws and knobs are firmly secured
Use for seating only one person at a time

x5
Castor
x1
Base
x1
Gas Lift
x3
Telescopic Covers
x1
Seat Plate
x1
Seat Cushion
x1
Back Cushion
x1
J Bar
x1
Cover
A
BC
F
DE
HI
PARTS LIST
G

x4
Screws
x1
Allen Wrench
x2
Screws
13
HARDWARE LIST
2

Place the Base (B) upside down on the ground, insert the Castors (A) as
shown in the diagram.
STEP 1

STEP 2
Turn the Base (B) right side up, insert the Gas Lift (C) & Telescopic Cover
(D) into the center hole of Base (B) as shown in the diagram.

x4 x1
STEP 3
Attach Seat Plate (E) to Seat Cushion (F) using Screw (1) and Allen Wrench
(3) as shown in the diagram. Fully tighten all screws.
FRONT
Remove the knob in part (H).

H
H
Remove the knob in J Bar (H).
STEP 4

STEP 5
x2x1
Use Screws (2) to fix the J Bar (H) onto Back Cushion (G). Put the
Cover (I) onto the Back Cushion (G) as shown in the diagram.
H

STEP 6
Slide the end of J Bar (H) into the Seat Plate (E) and secure using the
previously removed knob. Fully tighten the knob.
H
H