real living BL-EC2 User manual

A
Base
B
x1
KD Metal Leg
x5
CD
Seat Plate
x1
E
Seat Cushion
x1
Caster
x5
F
HARDWARE LIST
F
x1
Back Cushion
H
x1
Gas Lift
x1
I
J-Bar
Bolts
G
x4
M6x25mm
Bolts
G1
x4
Bolts
G3
x5
Bolts
G2
x4
Allen Wrench
L
x1
G
M6x25mm
G1 G3
G2
M8x20mm M8x30mm M6x15mm
Spare Bolts
x1 x1 x1 x1
Spare Bolts Spare Bolts Spare Bolts
M8x20mm M8x30mm M6x15mm

BCG3
Insert KD Metal Legs (B) into the Base
(С) and secure with 5 Bolts (G3). Tighten
all the bolts with the enclosed Allen
Wrench (L).
Warning: Fully hand-tighten all 5 bolts
at each leg/hub connection. Be careful
not to over tighten or strip bolts. Do not
use power tools.
G3
A
A
Turn the Star Base (С) upside down.
Press the Casters (A) into holes at the
end of each leg.
C
C
L
M6x15mm

H
H
Turn the Star Base (С) upright
and insert Gas Lift (H) into the
center hole of Star Base (C).
C
C
F
FIL
GG
G
x4
M6x25mm
C
F
F
I
Attach J-Bar (I) to the assembled
Back Cushion (F) using 4 Bolts (G)
as shown. Tighten all the bolts
with the enclosed Allen Wrench (L).

G1
M8x20mm
x4
G1
Align Seat Plate (D) over pre-drilled holes
on the underside of the Seat Cushion (E)
with front of seat plate facing the front of
the seat cushion. Attach the Seat Plate (D)
to Seat Cushion (E) using 4 Bolts (G1) as
shown. Tighten all the bolts with the
enclosed Allen Wrench (L).
E
D
Attach the Back Cushion (F) to Seat
Cushion (E) using 4 Bolts (G2) as
shown. Tighten all the bolts with the
enclosed Allen Wrench (L).
STEP 5
STEP 6
E
D
G2
M8x30 m m
x4
L
L
GG2

STEP 8
The Chair is fully assembled.
You can adjust the chair height by lifting
the flat-surfaced handle.
Align the center hole on the Seat Plate (D)
with the top of the Gas Lift (H) and press
firmly into place.
STEP 7