real living SEVEN HILLS BUCKET OFFICE CHAIR HG-1371-3... User manual

MAINTENANCE:
WARNINGS:
GENERAL BEST PRACTICES FOR ASSEMBLY:
Read all instructions before starting.
Separate all parts before starting.
Clear a flat covered space to assemble.
If parts are missing, broken, damaged or worn, stop using the product until all repairs are made.
Always keep children under close supervision while they are using or around this product. Never leave children
unattended. This product is intended for domestic, indoor use only, not intended for commercial use.
Do not stand or step on this chair.
Do not rock back and forth on this chair. Use for seating only one person at one time.
Do not use this product unless all bolts and screws are firmly secured.
Do not tighten screws before all screws are in the right place.
Do not exceed maximum weight capacity of 225lbs (102kg.)
Some parts may contain sharp edges. Wear protective gloves if necessary.
Wipe clean with a dry cloth for the upholstery and frame. Do not use bleach, acid or other abrasive cleaners.
Check that all bolts and screws are securely tightened at least every 3 months.

PARTS LIST
HARDWARE LIST
x4
M6x20mm Screw
x4
M6x25mm Screw
x1
Allen Wrench
21 3
x1
Seat Cushion
x1
Seat Plate
G
BD
C
E
x1
Back Cushion
FG
x3
Telescopic Cover
x5
Castor
x1
Base
x1
Gas Lift
A

HELPFUL HINTS
NOTE: To avoid damage,
ensure screws are hand
tightened. DO NOT USE
POWER TOOLS TO
ASSEMBLE YOUR UNIT.
1 person

STEP 1
x5x1
A B
Place the base (B) upside down on the ground. Insert the five castors (A) into the base as
shown in the diagram, make sure all castors are firmly inserted.
A
B

STEP 2
x1
C
x3
D
Turn the base (B) right side up, insert gas lift (C) as shown in the diagram, and place
telescopic cover (D) over the gas lift (C).
C
D
B

Attach the back cushion (F) to the base of the seat cushion (G) with screws (1) using allen
wrench (3) as shown in the diagram. Do not full tighten the screws until all screws are in
place.
x 1 x 1
FG1
x 1
3
STEP 3
x 4
F
G
1
3

3
E
E
2
x 4
2
3
G
Attach the seat plate (E) to the base of the seat cushion (G) with screws (2) using allen
wrench (3) as shown in the diagram. Do not full tighten the screws until all screws are
in place.
STEP 4

STEP 5
Carefully lower the seat plate (E) onto the gas lift (C) as shown in the diagram. The assembly is
complete, ensure all screws are tightened before use.
EC