Reer FMC-S User manual

www.reer.it
8540459 – Rev.3 3/4
FMC-S
COLUMN FOR MIRRORS
GENERAL
These mounting instructions contain information about the mounting of the FMC-S column with integrated
mirror on the FMC-CB stand bottom and about their alignment.
For information about the mounting of the stand bottom and the function of the light curtains, please see
the respective mounting and wiring instructions.
ASSEMBLY WITH THE FMC-CB STAND BOTTOM (Fig. 1)
•Mount the FMC-CB stand bottom on the floor (see mounting instruction for stand bottom).
Please note:
For a correct alignment, please verify that the stand bottom upper surface is even
and horizontal (using a circular spirit level.)
To operate the regulation, act on the three hexagonal nuts B (fig.2) until the perfect
levelness is reached. (Maximum adjustment: 10mm).
If the ground roughness is over 10mm, flush it adequately.
•Loosen the three socket head screws and remove the washers.
•Assembly the column to the stand bottom, centering the FMC-S column rotation flange with the
guides of the FMC-CB stand bottom upper plate.
•Fix the column tightening the three socket head screws and the washers.
Figure 1

www.reer.it
8540459 – Rev.3 4/4
ALIGNMENT AND ADJUSTMENT (Fig: 2)
•Ensure that the stand with integrated mirror is in a vertical position (placing a spirit level (A) on the top
end of the stand).
•Perform fine adjustments by means of the mounting screws (B) of the stand bottom.
•Connect the light curtain / the light grid.
•Verify, standing near the receiver axis, that the entire emitter shape appears on the first mirror as
follows:
•For an exact alignment of emitter, receiver and stand with integrated mirror, loosen the three socket
head screws that fix the stand (C) and turn the columns until the receiver receives the light signal
emitted by the emitter in an optimal way (when looking from the emitter position, you must see the
receiver in the mirror and vice versa).
•Then fix the position of the stand by tightening the three socket head screws and the washers (C).
Figure 2
DIMENSIONS
Figure 3
SPIRIT LEVEL
MODEL FMC-S2 FMC-S3 FMC-S4
DIMENSION 'A' (mm) 1000 1200 1330
DIMENSION 'B' (mm) 1055 1255 1385
MODEL FMC-S1700 FMC-S2000
DIMENSION 'A' (mm) 1700 1970
DIMENSION 'B' (mm) 1755 2025