ResMed AirTouch N20 Assembly instructions

ResMed.com/AirTouchN20
* CPAP users rated mask criteria on a Likert Scale of 0-10. A ‘comfortable mask’ is equal to a score of 8 or higher. An ‘excellent seal (no leak)’ is equal to a score of 10. ‘Easy to use’ is defined as easy to fit, adjust and remove.
† CPAP users rated mask criteria on a Likert Scale of 1-5. Scores were 4 (Good) to 5 (Very good).
‡ AirTouch N20 is validated at therapy pressures up to 30 cmH20
1ResMed guided external clinical study of 25 evaluable, existing CPAP mask users from Mar. 15 to Apr. 5, 2018, in Bella Vista, AU who trialed ResMed AirTouch N20 and ResMed AirFit™ N20 at home for 7 nights each in place of their
prescribed nasal mask. 2ResMed guided external clinical study of 29 evaluable CPAP users from Sept. 11, 2017, to Feb. 19, 2018, in San Diego, CA, who trialed AirTouch F20 at home for 30 nights each in place of their prescribed mask.
Distributed by ResMed Corp, 9001 Spectrum Center Boulevard, San Diego, CA 92123 USA [phone] or [phone] (toll free). See ResMed.com for other ResMed locations worldwide. AirFit, AirTouch, InfinitySeal and UltraSoft are
trademarks and/or registered trademarks of the ResMed family of companies. Specifications may change without notice. For patent and other intellectual property information, see ResMed.com/ip. © 2020 ResMed. 10111154/2 2020-02
1
Fitting guide for AirTouch N20
• Undo the fastening tabs on the lower
headgear straps.
• Adjust the straps evenly until the mask
is stable.
• Reattach the fastening tabs.
• Twist and pull both magnetic clips away
from the frame.
• With both lower headgear straps released,
hold the mask against the patient’s face.
• Pull the headgear over the patient’s head,
ensuring that the ResMed logo on the
headgear is facing up.
• Bring the lower straps below the
patient’s ears and attach the magnetic
clip to the frame.
• Undo the fastening tabs on the upper
headgear straps.
• Adjust the straps evenly until the mask sits
comfortably just over the nose.
• Connect the air tube on the device to the
short tube.
• Attach the elbow to the mask. First, press
the elbow’s side buttons, and then push
the elbow into the mask, ensuring it clicks
in on both sides.
• Start the device.
Refer to the user guide for further instructions
and complete labeling information, including
indications, contraindications, warnings
and precautions.
4 5 6
2 3
Incorrect
position Correct
position