Rhino-Rack S400-FK2 User manual

S400-FK2 EUROPEAN Bar 32mm x 22mm
2
Place the carrier and U-bolt over the crossbar. Insert
the European bar adaptor block, flat washers and
knobs onto the U-bolt.
Insert the U-bolt through the kayak / canoe carrier
mounting holes (front or back holes).
Adjust the carriers to suit the kayak or canoe, then tighten the knobs to secure the carriers.
Place these instructions in the vehicle’s glove box after installation is complete.
Important: Please read these instructions carefully prior to installation.
Please refer to your fitting instruction to ensure that the cross bars are installed in the correct locations.
Check the contents of kit before commencing fitment and report any discrepancies.
Parts List
1
2
3
4
Item Component Name Qty. Part No.
1 M6 U-Bolt 4 C064
2 European Bar “U” Adaptor Block 4 M083
3 M6 x 16mm x 1.6mm Flat Washer 8W031
4 M6 Plastic Knob 8N008
5 Fitting Instruction 1 RS-273
1
3

2
Below are the 2 positions in which the carriers can be
fitted to suit various kayak / canoe shapes. When using
the tie down straps provided please fasten as shown
below. After securing the kayak or canoe, check the
load for safety.
1
Insert the rubber kayak / canoe support pad cut out into
the carrier housing locating bar.
Rhino-Rack
3 Pike Street, Rydalmere, Document No: RS-273
NSW 2116, Australia. Prepared By: Craig Jones Issue No: 02
(Ph) [phone] Authorised By: Gary England Issue Date: 19/10/2006
(Fax) [phone]
These instructions remain the property of Fetovu Pty Ltd T/as Rhino-Rack and may not be used or changed for
any other purpose than intended.
1
2
Long loads must be secured front and rear as shown below.
Kayak / Canoe Carrier Loading Instruction
Long Load Instruction
Please Note: The maximum permissible roof load must not be exceeded (see vehicle hand book for details of
the maximum roof load).
The roof load comprises the weight of the basic rack plus the additional accessory and load itself.
Check that the rack system is securely fitted before each trip and at regular intervals.
Sensitivity to cross winds, behaviour in curves and braking:
The handling of the vehicle changes when transporting a load on the roof. For safety reasons,
we recommend you exercise extreme care transporting wind resistant loads.