Rightline Gear 100605 User manual

Add the Rear Car Clips (Fig 1) to the side straps of the
Rightline Gear Car Back Carrier to attach the carrier to
vehicles WITHOUT a roof rack (Fig 2).
1- Place the Car Back Carrier top side up. Extend one of
the long side straps out. Make sure the strap is not twisted
(Fig 3 and Fig 4).
2-Remove the male buckle from the strap. Make sure the
other parts are positioned as shown (Fig 5).
3-Add the Rear Car Clip and the male buckle onto the
strap (Fig 6). Make sure the strap goes through the correct
side of the buckle (Fig 6 Close-Up)
Fig 1 Fig 2
The correct attachment of this product is critical and
beyond the control of Rightline Gear. The safe use
and long life of this product depends entirely on
your good judgment and following these directions.
Fig 4
Fig 3
Male
Buckle
Pad
Tri-glide
Strap End
Strap
Male
Buckle
Male
Buckle
Fig 7
Fig 6
4-Run the strap back through the buckle, the Rear Car Clip,
the pad, and the tri-glide. (Fig 7).
5-Repeat steps 1-4 for the second long side strap.
Male
Buckle
Pad
Tri-glide
Strap End
Strap
Pad
Pad
Tri-glide
Tri-glide
Strap
Strap
Strap End
Strap End
Grooves
Rear
Car Clip
Rear
Car Clip
Fig 5
Fig 6 Close-Up
Male
Buckle
Rear
Car Clip
Top Side
Rear Car Clips Set Up Guide 100605
www.rightlinegear.com/setup.html
Set Up
Video:

8-Buckle the long side straps into the short side straps (Fig
10), testing that the buckle is fully engaged.
6-Place the Rear Car Clips in the gap between the ve-
hicle’s rear hatch door and roof (Fig 8).
7-Make sure the protective pads are face down on the top
rear corner of the vehicle (Fig 9).
Fig 10
Fig 8
Fig 9
Please see the Car Back Carrier Set Up Guide for additional
instructions.
1 Year Manufacturer’s Limited Warranty
www.rightlinegear.com/product-warranty.html