ring 5D22E5 User manual

Important Product
Information

SAFETY INFORMATION: FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS
COULD RESULT IN FIRE, ELECTRIC SHOCK, OR OTHER INJURY OR DAMAGE.
Small parts may pose choking hazards. Keep device and box contents out of reach of
children. Your device can withstand outdoor use and has been tested to withstand water
projected through a 12.5mm nozzle at a volume of 100 liters per minute and a pressure
of 100 kPa at a distance of 3 meters for at least 3 minutes. However, your device is not
intended for underwater use. To protect against electric shock, do not intentionally sub-
merge or immerse your device in water or expose your device to other liquids. Do not spill
any food or beverages on your device. Do not attempt to clean or polish your device with or
expose your device to oil, lotion, or other abrasive substances. Do not expose your device
to pressurized water, high velocity water, or extremely humid conditions (such as a steam
room). Do not attempt to dry your device with an external heat source, such as a micro-
wave oven or a hair dryer. To avoid risk of electric shock, do not touch your device or any
wires connected to your device during a lightning storm while your device is plugged in.
If your device appears to be damaged, discontinue use immediately.
BATTERY SAFETY
HANDLE WITH CARE. This device may require batteries for use. Only use battery types
that are specified for use with your device to power your device. Do not use any other
type of battery to power your device. Do not mix old and new batteries. Install batteries
with correct polarity. Do not disassemble, open, crush, bend, deform, puncture, or shred
the battery in your device. Do not modify or remanufacture the battery, attempt to insert
foreign objects into the battery, or immerse or expose it to water or other liquids, expose
to fire, explosion or other hazard. Do not short-circuit the battery or allow metallic con-
ductive objects to come into contact with battery terminals. Avoid dropping the device or
battery. If the device or battery is dropped, especially on a hard surface, and the user sus-
pects damage, do not attempt repair. Contact Ring Customer Service for assistance. Keep
batteries out of reach of children. Remove all batteries before storing your device for an
extended period of time. Replace batteries at regular intervals. Dispose of all batteries in
accordance with applicable laws and regulations.
Your device contains a removable, rechargeable lithium-ion Ring-branded battery. Only use
the USB charging cable or solar panel that is provided in-box to recharge the battery. Do
not use the battery with any device for which it has not been specified. Use of an unqual-
ified battery or charger may present a risk of fire, explosion, leakage or other hazard..
Product Specifications
Device Name: Ring Smart Lighting Wall Light Solar
Model Number: 5D22E5
Electrical rating: 5V DC 1A, 2 x 18650 Li-ion battery
Operating conditions: -4˚F to 122˚F (-20˚C to 50˚C)

This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide rea-
sonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment o and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Pursuant to Section 15.21 of the FCC rules, changes or modifications to a Product by
the user that are not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
The device meets the FCC Radio Frequency Emission Guidelines. Information on the
product is on file with the FCC and can be found by inputting such Product’s FCC ID
(which can be found on the device) into the FCC ID Search form available at https://
www.fcc.gov/oet/ea/fccid.
The party responsible for FCC compliance is:
Ring LLC, 1523 26th St, Santa Monica, CA USA, 90404
Information Regarding Exposure to Radio Frequency Energy
The output power of the radio technology used in the Product is below the radio frequency
exposure limits set by the FCC. This device should be installed and operated with a mini-
mum distance of 20cm between the radiator and your body. It is advised to use the Product
in such a manner that minimizes the potential for human contact during normal operation.

RECYCLING YOUR DEVICE PROPERLY
In some areas, the disposal of certain electronic devices is regulated. Make sure you dispose
of, or recycle, your device in accordance with your local laws and regulations. For informa-
tion about recycling your device, go to www.amazon.com/devicesupport.
Terms of Service and Warranty
By purchasing or using the product, you agree to the Terms of Service found at
ring.com/terms.
For information on our warranty and Ring Protect Plans, see ring.com/legal.
Ring LLC 1523 26th St. Santa Monica, CA 90404 USA
© 2021Ring LLC or its affiliates.
Ring and all related marks are trademarks
of Ring LLC or its affiliates.
XXXXXXXXXXXX

IMPORTANT PRODUCT INFORMATION
FOR UNITES STATES CUSTOMERS
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Information on this device is on file with the FCC and can be found by
inputting the device’s FCC ID into the FCC ID Search form available at
https://www.fcc.gov/oet/ea/fccid.
The output power of the radio technology used in the Products is below the
radio frequency exposure limits set by the FCC. Nevertheless, it is advised to
use the product in such a manner that minimizes the potential for human
contact during normal operation. This device should be installed and
operated with at least 20 cm between the radiator and your body.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment o and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly
approved by manufacturer could void your authority to operate this
equipment.
For information about recycling your device, go to
www.amazon.com/devicesupport
10/14/20 5:25 PM1 10/14/20 5:25 PM
FOR CANADIAN CUSTOMERS
Innovation, Science and Economic Development Canada (ISED)
Compliance.
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-
exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
Caution: Any changes or modifications to this device not explicitly
approved by manufacturer could void your authority to operate this
equipment.
Information Regarding Exposure to Radio Frequency Energy
This equipment complies with IC RSS-102 RF exposure limits set forth for an
uncontrolled environment.
This equipment should be installed and operated with a minimum distance
of 20 cm between the radiator and your body.
POUR LES CLIENTS CANADIENS
Conformité Innovation Sciences et Développement Économique Canada
(ISDE)
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est
conforme aux CNR d’Innovation, Sciences et Développement économique
Canada applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage.
(2) l’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
Renseignements relatifs à l’exposition à l’énergie des radiofréquences
Cet équipement est conforme aux limites d’exposition IC CNR-102 prévues
pour des environnements non contrôlés.
Cet équipement doit être installé et utilisé avec un minimum de 20 cm de
distance entre la source de rayonnement et votre corps.
CAN ICES-3 (B)/NMB-3(B)