RiverRidge Kids 6 Cubby Storage Activity Table User manual

ASSEMBLY INSTRUCTIONS
Kids 6 Cubby Storage Activity Table
White
ADULT ASSEMBLY REQUIRED
This product requires assembly by an adult because of small parts. Care should be taken
in unpacking and assembling this item to keep small parts away from children. During assembly
children should be kept away from the product due to possible risk of injury.
WARNING SEE FULL WARNING ON PAGE 2
Young children can be seriously injured or killed if furniture tips over. Don’t use
this item for a TV stand or place heavy objects on top of item. Always use
angle-braces or anchors to secure furniture to the wall.

This product is suitable for children 3 years and older.
THIS ACTIVITY TABLE WILL HOLD UP TO 20 POUNDS PER CUBBY AND HAS A
TABLETOP CAPACITY OF 75 POUNDS OR A TOTAL OF 195 POUNDS. DO NOT LOAD
EACH CUBBY WITH MORE THAN 20 POUNDS OR THE TABLETOP WITH MORE THAN 75
POUNDS. IF OVERLOADED WITH MORE THAN 20 POUNDS PER CUBBY OR 75 POUNDS
ON THE TABLETOP, THIS MAY CAUSE DAMAGE TO THE TABLE AND MAY CAUSE
SERIOUS INJURY OR DEATH.

PARTS LIST
NO
QTY
DESCRIPTION
1
1PC
Top Board
2
1PC
Bottom Board
3
2PCS
Side Panel
4
2PCS
Support Board
5
3PCS
Divider Board
6
6PCS
Leg

PARTS LIST
NO
PARTS
QTY
DESCRIPTION
A
8PCS
Cam Bolt
B
8PCS
Cam Lock
C
16PCS
Wood Dowel
D
8PC
Screw (4x35mm)
E
6PC
Screw (5x40mm)
F
1PC
Allen Wrench
TOOLS NEEDED FOR ASSEMBLY: FLAT & PHILLIPS SCREWDRIVER (NOT INCLUDED)
THE USE OF A POWER SCREWDRIVER IS NOT RECOMMENDED FOR ASSEMBLY
DO NOT USE ITEM IF ANY PARTS ARE MISSING OR DAMAGED

STEP 1
1. Screw 8 cam bolts (A) into cam bolt holes on top board (1).
STEP 2
1. Insert 8 wood dowels (C) into wood dowel holes on top board (1).
2. Attach 2 side panels (3) to top board (1) by inserting wood dowels (C) into wood dowel
holes and inserting cam bolts (A) into cam lock holes on side panels (3).
3. Insert 4 cam locks (B) into cam lock holes on side panels (3), then rotate clockwise to
secure cam bolts (A) in place.
4. Attach 2 support boards (4) to top board by inserting wood dowels (C) into wood dowel
holes and inserting cam bolts (A) into cam lock holes on support boards (4).
5. Insert 4 cam locks (B) into cam lock holes on support boards (4), then rotate clockwise to
secure cam bolts (A) in place.