RiverRidge 16-028 User manual

ASSEMBLY INSTRUCTIONS
RiverRidge® Woodbury Shoe Cabinet
ITEM #: 16-028
ADULT ASSEMBLY REQUIRED
This product requires assembly by an adult because of small parts. Care should be taken
in unpacking and assembling this item to keep small parts away from children. During assembly
children should be kept away from the product due to possible risk of injury.
WARNING SEE FULL WARNING ON PAGE 2
Young children can be seriously injured or killed if furniture tips over. Don’t use
this item for a TV stand or place heavy objects on top of item. Always use
angle-braces or anchors to secure furniture to the wall.

THIS SHELF UNIT WILL HOLD UP TO 20 POUNDS PER SHELF AND TOP BOARD FOR A
TOTAL OF 100 POUNDS. DO NOT LOAD SHELVES OR TOP BOARD WITH MORE THAN 20
POUNDS. OVERLOADING WITH MORE THAN 20 POUNDS PER SHELF OR TOP BOARD OR
100 TOTAL MAY CAUSE SHELF TO TIP FROM WALL AND CAUSE DAMAGE TO THE SHELF
OR SERIOUS INJURY OR DEATH.

PARTS LIST
NO
QTY
DESCRIPTION
1
1PC
Top Board
2
1PC
Adjustable Shelf
3
1PC
Fixed Shelf
4
1PC
Fixed Shelf
5
1PC
Bottom Board
6
1PC
Left Side Panel
7
1PC
Right Side Panel
8
1PC
Upper Back Board
9
1PC
Lower Back Board
10
2PCS
Door
11
4PCS
Metal Leg

PARTS LIST
NO
PART
QTY
DESCRIPTION
A
12PCS
Cam Bolt
B
12PCS
Cam Lock
C
16PCS
Wood Dowel (8x30mm)
D
4PCS
Screw (4x35mm)
E
8PCS
Machine Screw (6x30mm)
F
8PCS
Washer
G
4PCS
Shelf Holder
H
4PCS
Hinge
I
24PCS
Screw (4x14mm)
J
2PCS
Adjustable Anchor Bracket
K
2PCS
Screw (4x14mm)
L
20PCS
Screw (2.5x10mm)
M
2PCS
Plastic Anchor
N
2PCS
Handle
O
4PCS
Machine Screw (4x18mm)
P
2PCS
Screw (4x30mm)
TOOLS NEEDED FOR ASSEMBLY: FLAT & PHILLIPS SCREWDRIVER (NOT INCLUDED)
THE USE OF A POWER SCREWDRIVER IS NOT RECOMMENDED FOR ASSEMBLY
DO NOT USE ITEM IF ANY PARTS ARE MISSING OR DAMAGED
To order replacement p a r t s a t n o c o s t t o y o u , e m a i l [e-mail], call
1-(844)-223-5201 or order parts online at www.riverridgehome.com. Only valid in the United States.
If purchased outside of the United States, please contact retailer where purchased.

STEP 1
1. Screw 4 cam bolts (A) into cam bolt holes on top board (1).
2. Attach brackets (J) to top board (1) by inserting 2 screws (K) through holes on brackets (J),
then tighten to top board (1).
STEP 2
1. Screw 4 cam bolts (A) into cam bolt holes on left side panel (6).
2. Screw 4 cam bolts (A) into cam bolt holes on right side panel (7).