Riverside Belmeade 15832 User manual

15832 L-DESK & RETURN
Page 1 of 2
Made in China
Components and Hardware List
Belmeade
Home Office
Assembly Instructions
FURNITURE
Riverside
11 pc. 21 pc. 31 pc.
4
Pedestal
1 pc.
Bun Feet
711 pcs. 8
Wood Shelf
1 pc.
Pencil Tray
92 pcs.
A8 pcs.M1/4"x 1-1/2"
B
C
D
E
F
G
H
I
M5/16"x 2-3/4" 4 pcs.
2 pcs.
4 pcs.
M5/16"x 1-3/4"
M5/16"x 1-1/4"
4MM
5MM
1 pc.
1 pc.
Shelf Pins 4 pcs.
File rod (Installed)
14-1/2 long 2 pcs.
J
Wood Screw
(Installed)
Mending Plate
(Installed)
4 pcs.
4 pcs.
2
1
3
4A
E
D
F
D
F
C
F
To remove the drawer:
A. Pull the drawer fully open so the black lever is visible in the inside channel of the guides.
B. Push 'down' on the right lever and 'up' on the left lever. While holding levers in place,
pull drawer forward until slides release. If the slides will not release, push both levers in
opposite directions.

Riverside
FURNITURE
Belmeade
Home Office
Assembly Instructions
Made in China
Page 2 of 2
15832 L-DESK & RETURN
56
F
B
B
F
9
8
5
6
7
7
ASSEMBLY STEPS :
9. Position the Main Desk on it's back, on a soft surface such as a blanket or carpet. Attach the Bun Feet
underneath the corners.
10. Set the Main Desk upright and move to it's final location in the room.
11. Move the assembled Return Desk into position in front of the Main Desk.
12. Attach the Knee-Hole Section and Knee-Hole Back Panel of the Return Desk to the Main Desk, using the
5/16 x 2-3/4" long Bolts and Washers (B). Tighten Bolts with the 5mm Allen Wrench (F).
13. Adjust the adjoining edge of the Return Desk Top for a snug fit with the front edge of the Main Desk top.
14. After final adjustments are complete, using the 4mm Allen Wrench (E), reach underneath the Return
Desk Top and tighten the eight Bolts attaching the Return Desk Top.
15. Carefully reinstall the drawer by aligning the channels on the drawer with the ball bearings in the
channels of the cabinet members and gently pushing the drawer closed
16. The levelers installed in the bottom of the Bun Feet can be adjusted if necessary to compensate for uneven
flooring. After moving the Desk to it's final location in the room, using two people, have one person gently
lift the front of the desk while another person carefully reaches underneath and adjusts the levelers.
17. Install the Shelf Pins (G) into the selected level of holes. Place the Wood Shelf on the pins.
18. The File Drawer can be set up to use either Letter or Legal size hanging file folders using the File Rods
installed in the file drawer.
There is a two-outlet electrical fixture located at the back of each Knee-Drawer which can be used to
conveniently provide power for personal electronics, when connected to a wall outlet.
J