Rhein-Nadel Automation GmbH 2
VT-BA-ESK2001_EN-2019 / 22.08.2019 SJ
Table of Contents
1. About this document ..............................................................................................................4
2. Safety directives.....................................................................................................................4
2.1. Design of safety directives..................................................................................................4
2.2. Fundamental safety directives ............................................................................................4
2.3. Personnel............................................................................................................................4
2.4. Intended use.......................................................................................................................5
2.5. Residual hazards................................................................................................................5
2.5.1. Device ..........................................................................................................................5
2.5.2. Protection of the drive system......................................................................................5
2.5.3. Degree of protection - Protection of persons and equipment .......................................5
3. Product information................................................................................................................6
3.1. Characteristic features........................................................................................................6
3.2. Applicable directives and standards....................................................................................6
3.3. Technical data.....................................................................................................................6
3.4. Accessories ........................................................................................................................7
4. Notes on start-up....................................................................................................................7
4.1. Modes of operation.............................................................................................................7
4.2. Automatic mode change.....................................................................................................8
4.3. Sensor inputs and sensor linkages.....................................................................................8
4.4. Sensor connection..............................................................................................................9
4.5. Status outputs and relays .................................................................................................10
5. Operation .............................................................................................................................10
5.1. General.............................................................................................................................10
5.2. Starting-up the controller...................................................................................................11
5.3. Main menu / Setpoint entry and display for channels 1 and 2...........................................11
5.4. Description of individual codes for controller programming...............................................12
5.5. Application-specific change of default settings .................................................................14
5.5.1. Code C001 for channel 1 and code C002 for channel 2 (feed rate outputs) ..............14
5.5.2. Code C003 Seal setpoint ...........................................................................................14
5.5.3. Code C004 sensor input 1 and code C005 sensor input 2.........................................14
5.5.4. Code C006 Sensor linkage.........................................................................................15
5.5.5. Code C008 cycle monitoring ......................................................................................16
5.5.6. Code C009 Show status.............................................................................................17
5.5.7. Code C200 Inhibiting all code entries.........................................................................17
5.5.8. Code C100 Setting the feed rate by external voltage input........................................17
5.5.9. Code C143 Saving parameters..................................................................................18
5.5.10. Code C210 Retrieving parameters..........................................................................18
6. Dimensioned drawing...........................................................................................................18
7. Connection diagram.............................................................................................................19
