Rohnson R-2009-12 User manual

OIL-FILLED HEATERS
MODELS: R-2009-12 /R-2512-12
OPERATION MANUAL
DO NOT OPERATE WITHOUT CASTORS ATTACHED
READ AND SAVE THESE INSTRUCTIONS
IMPORTANT SAFEGUARDS
When using any electrical appliance, basic safety precautions should always be
followed, including the following.
1. To ensure familiarity with the controls, safety features, and operation of your heater-Read
all instructions before use.
2. To reduce hazard of injury due to electric shock:
-Danger of shock exists even when the appliance is switched off. ALWAYS unplug when is
not in use.
-Heater should never be used under conditions where it may be immersed, or come in
contact with water. Similarly do not plug in your heater if its surfaces are damp.
-The heater must not be located immediately below a socket-outlet.
-Warning: In order to avoid overheating, do not cover the heater.
-Do not use this heater in the immediate surroundings of a bath, a shower or a swimming
pool.
-Close supervision is required when any appliance is used by or near children.
-Disconnect the cord from the outlet before cleaning.
-Unplug heater by grasping plug and pulling it from the outlet. NEVER YANK ON CORD.
-When store your heater, keep it in a cool, dry place.
-The heater has a European plug. This plug will fit in a European outlet only one way. If the
plug does not fully fit the outlet, reverse the plug. If it still does not fit consult a qualified
electrician. Never use with an extension cord if the plug cannot be fully inserted.
-If the supply cord is damaged, it must be replaced by its service agent or a similar
qualified person in order to avoid hazard.
-This heater is filled with a precise quantity of special oil. Repairs requiring opening of the
oil container are only to be made by the manufacturer or his service agent who should be
contacted if there is an oil leakage. Regulations concerning the disposal of oil when
scrapping the appliance have to be followed.

WARNING
1. The surface temperature of the flanges is high, during use, thus closely supervise any child
in the area of this appliance.
2. Do not use on a wet place to prevent electrical shock.
3. Do not use out of the house.
4. If malfunctions happen during operation please put it nearby appointed service centre with
the maintenance card. Never disassemble it by yourself.
5. Be sure to pull out the plug from an outlet when not in use and before cleaning.
CAUTIONS FOR OPERATION
1 Never use the unit in places where are not even or unstable.
2 Do not insert and pull out the plug with wet hand, as this may cause electrical shock.
Power supply capacity should be enough.
3 The heater must only be used in the upright position. Never use when the unit is fallen
over.
4 The unit should be far away from the object flammable or easy deform during uses.
5 Do not allow smashing the surface with rod or sharp hard tools, as this may cause deform
and get rusty because of damage of paint coat.
6 Unit surface temperature of the flanges is high, thus do not touch it except handle, knobs.
7 Don’t heat wet clothing etc. on the surface of the control chamber, as this may cause
undue move of the thermostat.
PARTS AND ASSEMBLIES
TO ASSEMBLE
1. FIRST PUT THE UNIT UPSIDE DOWN;
2. LET THE “U” SHAPE SCREW SURROUNDING THE DOME OF THE RADIATING
FLANGES OF EACH END BETWEEN THE FIRST AND THE SECOND GROUPS OF THE
RADIATING FLANGES.
3. PUT TWO WHEELS AND SUPPORTING PLATE ASSEMBLIES ON THE UNIT AND
INSERT THE “U” SHAPE SCREW INTO TWO HOLES OF THE SUPPORTING PLATE.
4. INSERT THE BUTTERFLY NUTS AND SCREW THEM TIGHTLY COUNTER
CLOCKWISE.
5. STAND THE HEATER.

TO USE
1. Insert the plug into the suitable wall outlet.
-Never use the unit in place where is not even, make sure there is nothing flammable or
easy deform object within 1 meter (36 inches).
-Insert the plug after setting the thermostat to “OFF” position and setting the power
selected switches to “OFF” position.
- Do not cover the unit.
-The heater is suitable for operation on an A.C. electricity supply having the same
voltage as that show on it’s rating label.
2. Press two power switches to the "ON" position then turn thermostat to the "high" position,
at this moment, the unit begins to work, when the temperature rises to which you are
satisfied with, slowly turn the thermostat counter clockwise until the indicating light of the
key for power choice is out, and the room temperature thus can keep constant. If you
want to raise or lower the room temperature, you can make another regulation: Turn the
thermostat clockwise to raise the temperature and counter clockwise to lower it., or press
only one shift of power switches to “ON” position.
NOTES:
1) The pilot lamp will be on only if the temperature is below the setting value of the
thermostat.
2) The room must be sealed in good condition, if not, it will not make good result because
of the influx of heat.
3) The outlets of the control chamber must be kept ventilate, if not, undue move of the
thermostat may occur.
4) After use, turn the power switch to the “OFF” position first, then turn the thermostat to
the “OFF” position, and pull out the power supply plug.
CLEANING AND MAINTENANCE
1) The electric heater should be cleaned regularly to wipe out the dust on the surface of
flanges, as this may influence the radiating efficiency.
2) Disconnect electricity supply and allow radiator to cool, wipe out with a soft damp cloth. Do
not use detergent or abrasives.
3) Do not scrap the surfaces of flanges with sharp hard tools, to avoid surfaces getting rusty,
because of damage of the paint coat.
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN
ACCORDANCE WITH EC DIRECTIVE 2002/96/EC.
At the end of its working life, the product must not be disposed of as urban waste.
It must be taken to a special local authority differentiated waste collection centre or to a dealer
providing this service.
Disposing of a household appliance separately avoids possible negative consequences for
the environment and health, deriving form inappropriate disposal and enables the constituent
materials to be recovered to obtain significant savings in energy and resources. As a
reminder of the need to dispose of household appliances separately, the product is marked
with a crossed-out wheeled dustbin.