Rohnson R-8058 Owner's manual

1
IMPORTANT INSTRUCTIONS –
OPERATING MANUAL
OSCILLATING TOWER CERAMIC HEATER
MODEL: R-8058
READ AND SAVE THESE INSTRUCTIONS
READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR
MAINTAIN THE PRODUCT DESCRIBED.
PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION.
FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY
AND/OR PROPERTY DAMAGE.
RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.

2
IMPORTANT INSTRUCTIONS
When using electrical appliances, basic precautions should always be followed to
reduce the risk of fire, electric shock and injury to person, including the following:
1. Read all instructions before using heater.
2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If
provided, use handles when moving this heater. Keep combustible materials, such as
furniture, pillows, bedding, paper, clothes, and curtains at least 0.9 m from the front of the
heater and keep them away from the side and rear.
3. Extreme caution is necessary when any heater is used by or near children or invalids and
whenever the heater is left operating and unattended.
4. Always unplug heater when not in use.
5. Do not operate any heater with a damage cord or plug or after the heater malfunctions,
has been dropped or damaged in any manner. Return heater to authorized service facility
for examination, electrical or mechanical adjustment, or repair.
6. No not use outdoors.
7. This heater is not intended for use in bathrooms, laundry areas and similar indoor
locations. Never locate heater where it may fall into a bathtub or other water container.
8. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar
coverings. Arrange cord away from traffic area and where it will not be tripped over.
9. To disconnect heater, turn off the ROTARY POWER SWITCH on the top of unit to “O”
position, then remove plug from outlet.
10.Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this
may cause an electrical shock or fire, or damage the heater.
11.To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on
soft surfaces, like a bed, where openings may become blocked.
12.A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline,
paint, or flammable liquids are used or stored.
13.Use this heater only as described in this manual. Any other use not recommended by the
manufacturer may cause fire, electrical shock, or injury to persons.
14.Make certain that the power source conforms to the electrical requirements of the heater.
15.If the plug of heater does not fit fully in the outlet, contact a qualified electrician. Do not
attempt to defeat this safety feature.
16.Avoid the use of extension cords because the extension cord may overheat and cause a
risk of fire.
17.Heater is not located below a socket-outlet.
18.If the supply cord is damaged, it must be replaced by the manufacturer or its service agent
or a similarly qualified person in order to avoid a hazard.
19.This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
20.Children should be supervised to ensure that they do not play with the appliance.
21.SAVE THESE INSTRUCTIONS.
WARNING: DO NOT DEPEND ON THE ON/OFF SWITCH THE SOLE MEANS OF
DISCONNECTING POWER WHEN SERVICING OR MOVING THE HEATER. ALWAYS
UNPLUG THE POWER CORD.

3
FIX BASE
1. Guide the power cord through the center of the front base and connect the front base to
the main unit.
2. Fit the rear base onto the front base and the main unit.
3. Screw the four screws through base parts and into the
main unit.
4. Attach the power cord guard over the power cord and to
the rear base.
INFORMATION
Do not use your heater if it has not been fully assembled
make sure that the screws that hold the base pars and the
main unit together are tightened securely.
TECHNICAL SPECIFICATIONS
Working voltage: 220-240V/50Hz
Wattage: 1900W (+5%, -10%)

OPERATION INSTRUCTIONS
1. Carefully unpack your heater from box, please save the carton for off-season storage.
2. The heater must be placed on a firm, level surface.
3. Plug the cord set into a electrical outlet. Be sure plug fits tightly in outlet. A loose fit will
cause overheating and damage the plug. Plug and cord set may feel warm during normal
usage. Once plugged in, the Power Light will illuminate.
NOTE: Avoid overloading your circuit by not using other high wattage appliances in the
same outlet. At 1500 watts, this unit draws 12.5 Amps.
4. When turn on the Rotary power switch, the red light will come on indicating that there is
power to the unit. The red light will remain lit until the Rotary power switch is turned off
and the heater is unplugged from the electrical outlet.
5. Rotate the Rotary power switch to set the function,
0
Off Fan Low heat mode High heat mode
6. Turn on the Oscillating switch will allow the heater
to oscillate left and right. To stop the oscillation, turn
off the oscillating button.
7. To turn the heater off, rotate the Rotary power
switch to “O” position, then remove plug from power
outlet.
SAFETY FEATURES
1. A thermal overload protector is built in to prevent
overheating.
2. When an overheat temperature is reached, the
Oscillating
switch
Rotary power
switch

4
heater will be automatically shut off. It can only resume operation when the unit to cool
down.
TROUBLE SHOOTING TIPS
If your heater shuts off unexpectedly or fails to operate, one of the above-mentioned safety
features may have activated to prevent overheating.
1. Be sure the power cord is plugged into a working electrical outlet.
2. Check your thermostat setting. The heater may be off because it has reached the desired
temperature setting.
MAINTENANCE
WARNING: ALWAYS UNPLUG THE CORD BEFORE MOVING OR SERVICING.
DO NOT IMMERSE HEATER IN WATER!
CLEANING: IMPORTANT! DO NOT IMMERSE HEATER IN WATER! Clean the heater grills
with the vacuum brush attachment on your vacuum cleaner. This will remove lint and dirt from
the inside of the heater. DO NOT ATTEMPT TO TAKE HEATER APART. Clean the body of
heater with a soft cloth.
CAUTION: Do not use gasoline, benzine, thinner, harsh cleaners, etc. as they will
damage the heater. NEVER USE ALCOHOL OR SOLVENTS.
STORAGE: Store the heater with these instructions in the original carton in a cool, dry place.
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN
ACCORDANCE WITH EC DIRECTIVE 2002/96/EC.
At the end of its working life, the product must not be disposed of as urban waste.
It must be taken to a special local authority differentiated waste collection centre or to a dealer
providing this service.
Disposing of a household appliance separately avoids possible negative consequences for
the environment and health, deriving form inappropriate disposal and enables the constituent
materials to be recovered to obtain significant savings in energy and resources. As a reminder
of the need to dispose of household appliances separately, the product is marked with a
crossed-out wheeled dustbin.